Toshiba B-852-TS12-QP owner manual Head Pressure Adjust Lever

Page 22

2. PRINTER SETUP

ENGLISH VERSION EO1-33028

2.7 Loading the Media

2.7.3Loading Media into the Printer (Cont.)

NOTE:

The head pressure increases when the Head Pressure Adjust Lever is lowered. When using labels or thick tag paper, lower the Head Pressure Adjust Lever. If the print tone is light, lower the Head Pressure Adjust Lever even when using thin tag paper.

WARNING!

The Top Cover can be opened during the operation for control purposes only. It should be closed during normal operation.

10.After loading the media, don’t forget to move the Supply Holder Unit to the forward notch of the Supply Roll Frame as shown below.

11.If you are using labels or thick tag paper, then it may be necessary to increase the head pressure by lowering the Head Pressure Adjust Lever in the figure below.

Head Pressure

Adjust Lever

Head Pressure Adjust Lever Position

UP: Thin tag paper

DOWN: Label or Thick tag paper

E2-11

Image 22

Contents 852-TS12-QP List of Standard of Conformity 852-TS12-QP 6DIHW\6XPPDU\ Precautions Request Regarding MaintenanceTable of Contents EA2-1 E6-1EA1-1 EA3-1Product Overview Introduction FeaturesUnpacking Accessories Front View DimensionsAppearance Rear ViewOperation Panel InteriorPrinter Setup PrecautionsProcedure before Operation Assembling the Accessories Assembling the Supply Holder FrameConnecting the Cables to Your Printer Connecting the Power Cord Turning on the Printer Turning the PrinterTurning OFF the Printer Installing the Media onto the Supply Holder Unit Loading the MediaSpacer Supply Holder Printer Loading Media into the Printer Head Pressure Adjust Lever Setting the Feed Gap Sensor Setting the Black Mark SensorLoading the Ribbon Disconnect the mainsInserting the Optional Pcmcia Cards COMTest Print If necessary, the print test may now be repeated from step E2-17 Overview Printer OperationOperating Modes Operating Modes On Line Mode Operation PanelOperation Reset Dump Mode Restart keyPrint Conditions Cleaning MaintenancePrint Head/Platen/ Sensors Covers and Panels Optional Cutter ModuleTroubleshooting Error MessagesPossible Problems Possible Problems Causes SolutionsRemoving Jammed Media Threshold Setting Feed keyAppendix 1 Specifications A1.1 PrinterA1.3.1 Media Type A1.2 OptionsA1.3 Media LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaA1.4 Ribbon Symbols in the message Appendix 2 Messages and LedsFollowing message appears Appendix 3 Interface „Interface CablesAppendix 4 Print Samples Appendix 4 Print Samples UPC-A Glossaries Bar codePre-printed media Index Index