4.ON LINE MODE
ENGLISH VERSION
4.4 Dump Mode
4.4 Dump Mode
CAUTION!
Please do not select <2>PARAMETER SET and <3>ADJUST SET modes. They are selectable, however, the printer may malfunction if the values are not set correctly. For details, please refer to your nearest TOSHIBA TEC service representative.
In Dump mode, any characters sent from the host computer will be printed. Received characters are expressed in hexadecimal values. This allows the user to verify programming commands and debug the program.
1.The printer is turned on, standing by, or printing.
21/,1(
2.Press the [PAUSE] key.
3$86(
3.During the Pause state, press and hold the [RESTART] key for 3 seconds or more. The display shows “<1> RESET”.
!5(6(7
4.Press the [FEED] key. The display shows “<2>PARAMETER SET”.
!3$5$0(7(56(7
5.Press the [FEED] key. The display shows “<3>ADJUST SET”.
6.Press the [FEED] key. The display shows “<4>DUMP MODE”. Press the [PAUSE] key to enter the Dump Mode.
!'80302'(
NOTE:
If an error occurs during the receive buffer dump, the display will show an error message and the printer will stop printing. Clear the error by pressing the [PAUSE] key and the display will return to “<4>DUMP MODE”. Printing will not restart automatically.
7.Select the receive buffer to be dumped with the [FEED] or
[RESTART] key
%8))(556&
[RESTART] ∙
|
| ∙ CENTRO: Centronics Receive Buffer |
|
| |
[FEED] | ∙ NETWORK: Network Interface Receive Buffer | |
|
| |
8.Press the [PAUSE] key to start printing. The printer prints the data in the selected receive buffer.
12:35,17,1*
9.After completing the printing, the display returns to “<4>DUMP MODE”.
!'80302'(
10.Reset the printer by turning the power off and on. The display shows “ON LINE”.
21/,1(
E4- 3