2. PRINTER SETUP
ENGLISH VERSION
2.10 Inserting the Optional PCMCIA Cards
2.10Inserting the Optional PCMCIA Cards
CAUTION!
1.To protect PC cards, discharge static electricity from your body by touching the metal cabinet of the printer before touching the card.
2.Before inserting or removing a PCMCIA card make sure that the printer’s power is turned off.
3.Be sure to protect PCMCIA Cards when not in use by putting them into their protective covers.
4.Do not subject the card to any shocks or excessive force nor expose the card to extremes in temperature or humidity
5.The card may be inserted into the slot halfway even in the wrong orientation. However, the slot is safety designed so that the card will not be connected to the connector pins.
When the optional PCMCIA interface board is installed into the
1.Make sure that the printer’s power switch is in the OFF position.
2.Hold the PCMCIA Card so that the model name printed side faces right. Insert the card into the proper slot until the Eject Button pops out.
Slot 0:
(Memory type cards only)
Slot 1:
(I/O type cards such as LAN cards)
Eject Button
Model Name Printed Side
3.The following PCMCIA cards can be used.
Type | Maker | Description | Remarks | |||
ATA Card | San Disk | A card conforming to |
| |||
the PC card ATA | ||||||
Hitachi | ||||||
| standard |
|
|
| ||
|
|
|
|
| ||
|
|
|
|
| Install into the slot | |
LAN Card | 3 COM | Ether Link III |
|
| (1) only. (This card | |
3C589D PC card | installed into the slot | |||||
|
| |||||
|
|
|
|
| (0) will not work.) | |
Flash |
|
|
|
|
| |
| CC |
|
| |||
Memory | Maxell |
|
|
| ||
|
|
| ||||
Card (4 MB) |
| DC |
|
| ||
|
|
|
|
|
|