Ampro Corporation XTX 820 manual Third IDE Slave Not Detected or Device Type

Chapter 4 BIOS Setup Utility

♦S.M.A.R.T. – [Auto], [Disabled], or [Enabled]

♦32Bit Data Transfer – [Disabled] or [Enabled]

>Third IDE Slave: – [Not Detected] or [Device Type]

The descriptions used for the Primary IDE Master are the same for the Third IDE Slave except where noted.

∗If the BIOS does not detect a device on the Third IDE Slave channel, [Not Detected] will be displayed. You can still go to the submenu to set options for an IDE device.

∗If the BIOS auto detects a IDE device, the device will be displayed [Hard Disk for example] with the parameters automatically selected.

♦Type – [Not Installed], [Auto], [CD/DVD], or [ARMD]

∗If [Not Installed] appears due to Not Detected, the balance of the options for Third IDE Slave may not appear on screen.

♦LBA/Large Mode – [Disabled] or [Auto]

♦Block (Multi-Sector Transfer) – [Disabled] or [Auto]

♦PIO Mode – [Auto], [0], [1], [2], [3], or [4]

♦DMA Mode – [Auto], [SWDMA0], [SWDMA01], [SWDMA2], [MWDMA0], [MWDMA1], [MWDMA2], [UDMA0], [UDMA1], [UDMA2], [UDMA3], [UDMA4], [UDMA5], or [UDMA6]

♦S.M.A.R.T. – [Auto], [Disabled], or [Enabled]

♦32Bit Data Transfer – [Disabled] or [Enabled]

•Hard Disk Write Protect – [Disabled] or [Enabled]

>Fourth IDE Master: – [Not Detected] or [Device Type]

The descriptions used for the Primary IDE Master are the same for the Fourth IDE Master except where noted.

∗If the BIOS does not detect a device on the Fourth IDE Master channel, [Not Detected] will be displayed. You can still go to the submenu to set options for an IDE device.

∗If the BIOS auto detects a IDE device, the device will be displayed [Hard Disk for example] with the parameters automatically selected.

♦Type – [Not Installed], [Auto], [CD/DVD], or [ARMD]

∗If [Not Installed] appears due to Not Detected, the balance of the options for Fourth IDE Master may not appear on screen.

♦LBA/Large Mode – [Disabled] or [Auto]

♦Block (Multi-Sector Transfer) – [Disabled] or [Auto]

♦PIO Mode – [Auto], [0], [1], [2], [3], or [4]

♦DMA Mode – [Auto], [SWDMA0], [SWDMA01], [SWDMA2], [MWDMA0], [MWDMA1], [MWDMA2], [UDMA0], [UDMA1], [UDMA2], [UDMA3], [UDMA4], [UDMA5], or [UDMA6]

♦S.M.A.R.T. – [Auto], [Disabled], or [Enabled]

♦32Bit Data Transfer – [Disabled] or [Enabled]

74 Reference Manual XTX 820