Chapter 3 | Hardware |
Ethernet Port Interface
The Ethernet solution is provided by integrating the functions of I/O Hub (82801FBM) and the Intel 82562GZ Fast Ethernet PCI controller chip together. The Intel 82562GZ chip provides the physical layer (PHY) and the I/O Hub provides the Media Access Controller (MAC).
•Routed to J4 connector
•Supports full duplex or
•Supports full duplex operation at 10 Mbps and 100 Mbps
•Provides IEEE 802.3 10BaseT/100BaseT compatible physical layer and LAN connect interface
•Supports IEEE 802.3u
•Supports IEEE 802.3x
•Provides
•Provides PHY detection of polarity,
•Supports Auto MDI, MDIX crossover at all speeds
•Provides Digital Adaptive Equalization control
•Provides Link Status interrupt capability and XOR tree mode support
•Supports
•Supports diagnostic loopback mode
•Provides low power at 3.3 V (less than 300 mW in active transmit mode)
•Reduced power in "unplugged mode" (less than 50 mW)
•Provides automatic detection of "unplugged mode"
•Baseboard must provide the Ethernet
Table
J4 | Signal | Description | |
Pin # |
|
| |
97 | TX+ | Analog Twisted Pair Ethernet Transmit Differential Pair – These pins | |
|
| transmit the serial bit stream to the baseboard as differential signals. | |
95 | TX- | ||
| |||
|
|
| |
93 | RX | Analog Twisted Pair Ethernet Receive Differential Pair – These pins | |
|
| receive the serial bit stream from the baseboard as differential signals. | |
91 | RX- | ||
| |||
|
|
| |
| GND | Ground | |
10 | LILED | Link Integrity LED – The LINK LED pin indicates link integrity. If the | |
|
| link is valid in either 10 or 100 Mbps, the LED is on; if the link is | |
|
| invalid, the LED is off. | |
12 | ACTLED | Activity LED – The Activity LED pin indicates either transmit or receive | |
|
| activity. When activity is present, the activity LED is on; when no | |
|
| activity is present, the activity LED is off. | |
14 | SPDLED | Speed LED – The speed LED pin indicates the speed. The speed LED | |
|
| will be on at 100 Mbps and off at 10 Mbps. |
Note: The shaded area denotes power or ground.
48 | Reference Manual | XTX 820 |