Ampro Corporation XTX 820 manual Bios Security Setup Screen, To clear Supervisor password

Chapter 4BIOS Setup Utility

BIOS Security Setup Screen

BIOS Setup Utility

Main	Advanced	Boot	Security		Power	Exit
Security Settings							Install or change
Supervisor Password: Not installed							the password
User Password:		Not installed
Change Supervisor Password
Change User Password
Boot Sector Virus Protection				[Disabled]
Hard Disk Security								Select Screen
Hard Disk Security User Passwords
								Select Item
Hard Disk Security Master Passwords
							Enter	Change
							F1	General Help
							F10	Save and Exit
							ESC	Exit

V02.xx (C) Copyright 1985-2004, American Megatrends, Inc.

Figure 4-4. BIOS Security Setup Screen

Security Settings

•Supervisor Password – [Installed] or [Not Installed] Indicates if a supervisor password has been set.

∗If the password has been installed, Installed appears on screen.

∗If no the password has be selected, then Not Installed appears on screen.

•User Password – [Installed] or [Not Installed]

Indicates if a user password has been set. If the password has been installed, Installed displays. If not, Not Installed displays.

•Change Supervisor Password

a. Select Change Supervisor Password from the Security Setup menu. b. Press <Enter> to access the pop-up menu, Enter New Password:

c. Type the password and press <Enter> again.

The screen will not display the password as you type.

d. Retype the password when prompted by the pop-up menu and press <Enter> again.

If the password is not confirmed when you retype it, an error message will appear. The password is stored in NVRAM and you have successfully entered the password.

To clear Supervisor password: .

a.Press <Enter> to access the pop-up menu, Enter New Password:

b.Do not enter a password and press the <Enter> key, following the prompts.

c.Repeat this process until the old password is gone, which is indicated by Not Installed.

84 Reference Manual XTX 820