ADJUSTING SYSTEM PARAMETERS
Setting the TURN ON VOLUME
You can set the initial volume level when the power of this unit is turned on.
1Repeat steps 1 to 3 in “Using the system parameters” on page 76.
2Set the operation mode selector to YSP to switch to the operation mode of this unit.
TV/AV
YSP
3Press 
/ 
on the remote control so that TURN ON VOLUME is shown in the front panel display.
ENTER
VOL
TURN ON VOLUME
4Press ENTER.
ENTER
5Press 
/ 
to adjust the initial volume level.
ENTER
Control range: MAX, 99 to 01, OFF
Control step: 1
6Press STANDBY/ON on the front panel to set this unit to the standby mode.
STANDBY/ON
The new setting for the maximum volume level will be activated when you turn on the power of this unit next time.
Setting the DEMO MODE
You can test the beam output from this unit to experience the sound beam.
y
You can also perform this function simply by pressing INPUT on the front panel. A sound beam is output from this unit when you press and hold INPUT for more than 2 seconds. The sound beam shuttles between left and right twice, and then stops.
1Repeat steps 1 to 3 in “Using the system parameters” on page 76.
2Set the operation mode selector to YSP to switch to the operation mode of this unit.
TV/AV
YSP
3Press 
/ 
on the remote control so that DEMO MODE is shown in the front panel display.
ENTER
VOL