Yamaha YSP-1100 owner manual Show Result, 34 En, Side view, Example Optimizer microphone

AUTO SETUP (IntelliBeam)

8 Check that the following screen is displayed	10 Disconnect the optimizer microphone from
on your TV.	the OPTIMIZER MIC jack on the front panel.
The results of the AUTO SETUP procedure are
displayed on your TV.	Side view
Example 1

SHOW RESULT

MEASUREMENT COMPLETE

BEAM MODE :5 BEAM

SUBWOOFER :NOT APPLICABLE

[ENTER]:Save set-up. [RETURN]:Do not save set-up.

Example 2

Optimizer microphone

SHOW RESULT

MEASUREMENT COMPLETE

ENVIRONMENT CHECK[FAILED]

BEAM MODE :5 BEAM

SUBWOOFER :YES

[ENTER]:Save set-up. [RETURN]:Do not save set-up.

y

•If ‘‘ENVIRONMENT CHECK [FAILED]’’ is displayed, we recommend running the AUTO SETUP procedure again. For details, see step 9.

•If ‘‘SUBWOOFER : NOT APPLICABLE’’ is displayed even though a subwoofer is connected to this unit, increase the volume level of the subwoofer and run the AUTO SETUP procedure again.

•Depending on the environment of your listening room, the beam angle of front left and right, and surround left and right may be set to the same value even if 5BEAM is displayed as a result.

9Press ENTER to confirm the results or press RETURN to cancel the results.

The following screen is displayed temporarily for 2 seconds and then disappears from your TV.

AUTO SETUP COMPLETE

Please remove the MIC from

ENTERthe YSP and the listening position.

If ‘‘ENVIRONMENT CHECK [FAILED]’’ is displayed in step 8, the following screen is displayed after pressing ENTER. In this case, see ERROR E-1 in “Error messages for AUTO SETUP” on page 35. Press ENTER to exit the AUTO SETUP and then run the procedure again from step 3.

AUTO SETUP COMPLETE

Your YSP unit may not be set up correctly.

We recommend you try again.

Please press [ENTER] key to exit.

34 En