4Press 
/ 
to switch between DEMO: ON
and DEMO: OFF.
ENTER
ADJUSTING SYSTEM PARAMETERS
Setting the FACTORY PRESET
You can reset all of the parameters of this unit to the factory presets. This procedure completely resets ALL the parameters in SET MENU.
Note
After performing the following procedure you must run the AUTO SETUP again to match your surround sound environment.
VOL
DEMO: ON
VOL
DEMO: OFF
•Select DEMO: ON to activate the demo mode.
•Select DEMO: OFF to deactivate the demo mode.
5Press STANDBY/ON on the front panel to set this unit to the standby mode.
STANDBY/ON
The new setting will be activated when you turn on the power of this unit next time.
Press ENTER to test the sound beam.
The sound beam being output shuttles between left and right. Press ENTER again to stop shuttling.
1Repeat steps 1 to 3 in “Using the system parameters” on page 76.
2Set the operation mode selector to YSP to switch to the operation mode of this unit.
TV/AV
YSP
3Press 
/ 
on the remote control so that FACTORY PRESET is shown in the front panel display.
ENTER
VOL
FACTORY PRESET
4Press ENTER.
OPERATION | ADVANCED |
|
|
ENTER
English