MANUAL SETUP
HORIZONTAL ANGLE (Horizontal angle)
Use to adjust the horizontal angle of beams for each channel. By adjusting the horizontal angle of the beams, you can optimize the sound beam paths. A test tone is automatically output.
( ) | (+) |
(+) | ( ) |
Choices: L90° to R90°
Adjust towards L (left) to move the direction of the output to the left and adjust towards R (right) to move it to the right.
a)HORIZONTAL ANGLE 1/5
Front L |
| 5 beam | ||
|
|
|
| |
L65deg | L90 |
|
| R90 |
*
0(deg)
[p]/[p]:Up/Down [p]/[p]:Sel [ENTER]:Return
VERTICAL ANGLE (Vertical angle)
Use to adjust the vertical angle of sound beams for each speaker. By altering the beam path, you can optimize sound beam angles.
0°
Choices:
Initial setting: 0°
•Adjust towards – (minus) to move the angle downward.
•Adjust towards + (plus) to move the angle upward.
b)VERTICAL ANGLE 1/5
| 5 beam | |
Front L | (+) |
|
0deg. | ||
|
| |
|
|
|
[p]/[p]:Up/Down [p]/[p]:Sel [ENTER]:Return
Note
A test tone is automatically output.
BEAM TRAVEL LENGTH (Beam travel length)
A certain amount of delay must be applied to the sound from each channel so that all sound will arrive at the listening position at the same time. This menu sets the distance that sound beams travel after being output and reflected off the wall until they arrive at the listening position and adjust the delay applied to the respective channel.
The lines in the illustration below indicate the distance.
Choices: 0.3 m to 24.0 m
•Front L adjusts the distance the front left channel sound beams travel.
•Front R adjusts the distance the front right channel sound beams travel.
•Center adjusts the distance the center channel sound beams travel.
•Surround L adjusts the distance the surround left channel sound beams travel.
•Surround R adjusts the distance the surround right channel sound beams travel.
c)BEAM TRAVEL LENGTH
5 beam
. Front L;;;;;;;6.0m Front R;;;;;;;6.0m Center;;;;;;;;2.5m Surround L;;;;9.1m Surround R;;;;9.1m
[p]/[p]:Up/Down [p]/[p]:Sel [ENTER]:Return
y
We recommend that you use the setting optimized by the AUTO SETUP (see page 29). Set this menu only when you changed the HORIZONTAL ANGLE (see page 64).