How to Set a Document
How to Set a Document
In this manual a document can mean a single or multiple page document. You can set your documents either in the Auto Document Feeder (ADF) or document bypass tray.
Direction in Which Original is Set
The direction in which you should set the document in the Auto Document Feeder (ADF) depends on the docu- ment size:
❖How to set A4, B4, A3, LT, LG and DLT size documents
Original | Where Original is set |
R | R |
R | R |
GFGSET0N
❖How to set A5 and B5 size documents
Original | Direction in which to set document |
R |
|
|
|
| R | ||
|
|
|
|
R | R |
GFGSET1N
Note | 1 |
❒ When sending a fax, the image |
output at the other end depends on the size and direction of paper used in the receiver's terminal. If the receiver does not use paper of the same size and direction as that of the document, the fax image may be output reduced, trimmed at the both edges, or divided into two or more sheets. When sending an important document, we rec- ommend you to ask the receiver about the size and direction of the paper used in their terminal.
❒It is possible to set A4 Land A4 K documents as you would A5 or B5 documents, but there is no guaran- tee that they will be sent correctly.
❒Make sure that all ink, correcting fluid etc., has completely dried be- fore setting your document. If it is still wet, the scanner glass will be marked and those marks will ap- pear on the received image.
Setting Documents in the Auto Document Feeder (ADF)
Use the Auto Document Feeder (ADF) to scan in a stack of documents in one operation.
Limitation
❒You can scan in documents of up to 23.7" in length.
❒Place all the documents to be sent in a single stack.
❒You cannot set documents in the Auto Document Feeder (ADF) one page at a time or in sheaves.
35