Panasonic KX-FP151AL, KX-FP155AL manual Important information for Australian users, Installation

Page 4

Important information (for Australian users)!

Instructions to customer

Installation

Attached to this apparatus is an approval label. This label is evidence that it is a “PermittedAttachment” which has been authorised to be connected to your telephone service.

Conditions relating to connection and operation of this Permitted Attachment are contained in Telecommunications General By-Law 220 (5).

You are authorised to install this Permitted Attachment yourself by plugging it into the line socket of any regular telephone. You may connect it in place of your existing telephone or to any spare telephone socket installed in your premises.

To disconnect your existing telephone you must first remove its plug from the line socket. You can then insert the plug of your Permitted Attachment into the socket and use your equipment.

If the plug of your existing telephone cannot be readily removed, you will have to remove the screw securing it. To do this proceed as follows:

1.Loosen screw “A” sufficiently to remove the socket cover. (See Fig. 1.)

2.Remove screw “B” and withdraw the plug. (See Fig. 2.)

3.Replace screw “B”. (See Fig. 3.) Ensure that it screws completely into the socket recess. (If the screw is too long, increase the hole depth or replace the screw with one 5 mm shorter.)

4.Replace socket cover and tighten screw “A”. (See Fig. 4.)

SOCKET PLUG

SCREW “A”

Fig. 1

SCREW

“B”

Fig. 2

TELEPHONE CORD

)

 

Connect to the PLUG

 

( as shown in Fig. 1.

SCREW “A”

SCREW

 

SOCKET

“B”

 

Fig. 3Fig. 4

If you are satisfied with the operation of your telephone service after plugging in your Permitted Attachment, your installation is completed.

You will be unable to connect this Permitted Attachment if your telephone service consists only of a wall phone or an old style telephone which is not connected by means of a modern plug and socket. In such cases a new socket will need to be installed.

Should the Permitted Attachment not operate when plugged into a socket, it is either faulty or unsuitable for operation with your telephone service. It should be returned to the store where purchased.

Service difficulties

If at any time a fault occurs on your telephone service carry out the following checks before you call for service:

Disconnect the Permitted Attachment and try using the service with the normal telephone.

If the telephone service then operates satisfactorily, the fault is in your Permitted Attachment. Leave the Permitted Attachment disconnected and report the fault to its supplier or agent to arrange for repair.

If when using the telephone the service is still faulty, report the fault to “Service Difficulties and Faults” for attention.

You are required to keep this Permitted Attachment in good working order while it is connected to your telephone service. Its construction or internal circuit must not be modified in any way without permission.

4

Image 4
Contents Operating Instructions For your future reference CopyrightFor Australian users Service difficulties InstallationImportant information for Australian users Safety instructions Important safety instructionsTable of Contents Copy Accessories Included accessoriesAccessory information Model No Specifications / UsageHelp function Help ButtonHelp SET Finding the Controls OverviewLocation For New Zealand users onlyFor KX-FP155 Setup Ink film installing / replacingFor replacement only Pull out the blue gear and remove the usedCorrect Incorrect Please WaitRecording paper Paper trayTo add paper Connections Metal barTo use the fax machine with a computer on the same line Date and time, your logo and facsimile telephone number Setting the date and timeMenu SET Setting your logo StopRecall Menu SET MuteTo select characters with the dial keypad To select characters using +orDisplay order of characters Setting your facsimile telephone number System SET UP Press NAVI.I HSending Report Recall MenuVolume Adjusting volumeNavigator Directory Storing names and telephone numbers into the directoryHelpful hint To delete a character/numberEditing a stored entry Erasing a stored entryMaking a phone call using the directory Navigator Directory / RecordingRecording a telephone conversation KX-FP155 only Record StopCaller ID service from your phone company To confirm caller information using the Caller ID listCaller ID How Caller ID is displayedViewing and calling back using caller information Stop FAX/START Caller IDTo display the caller’s name Display while viewingErasing all caller information Erasing specific caller information KX-FP155 onlyMenuset Caller ID Stop EraseCaller ID Storing caller information into the directoryNAME=WENDY Storepress SET Voice Contact Initiating voice contactReceiving a request for voice contact Voice StandbySending a fax manually Sending FaxesHelp FAX/START SET Stop Documents you can send Sending a fax using the directory Stop FAX/STARTFax auto redial If your unit does not send a faxBroadcast transmission Programming entries into the broadcast memoryMenu Stop SETErasing a stored entry in the broadcast memory Adding a new entry into the broadcast memoryStop Menu SET To cancel the broadcast setting Sending the same document to pre-programmed partiesBroadcast Sendpress SET To send to selected parties only onceSetting the unit to receive faxes When receiving phone When receiving calls CallsWhen receiving faxes Receiving FaxesWhen receiving phone calls When receiving calls Fax receivingWith answering Machine KX-FP151 only Remote Fax activationActivating TEL mode TEL mode Answering all calls manuallyReceiving a fax manually FAX only mode All calls are received as faxes Activating FAX only modeFAX only Mode Auto AnswerDelayed ring setting Phone call Fax calling Recognition ring setting ToneTo set TEL/FAX mode Call is receivedWhen an extension telephone is connected Using the unit with an answering machine KX-FP151 only Setting up the fax machine and an answering machineHow the fax machine and answering machine work Receiving a voice message and fax document in one callReceiving phone calls Receiving faxesExtension telephone PollingPager call When your pager receives a pager callMenu SET REDIAL/PAUSE Using with the ring detection feature Setup ItemDistinctive Ring Ring DetectionCopying Making a copyNUMBER=1 Copypress Start Or Press NAVI. H Start Stop CopyTo reduce a document To enlarge a documentTo collate multiple copies Setup KX-FP155 only TAD/FAX mode Receiving phone calls and faxes automaticallySetting up the voice and fax message reception TAD/FAX ModeGreeting KX-FP155 only Recording your own greeting messagesRecord SetstopGreeting / Memo Message KX-FP155 only Erasing your own recorded greeting messagesLeaving a message for others or yourself Erase SET StopListening to recorded messages Incoming Messages KX-FP155 onlyPlay Messages Erase Slow Quick SET Stop Remote Operation KX-FP155 only Operating from a remote locationRemote operation card Recording a message in a mailboxWhen there are new messages When voice memory is fullKey Remote command Listening to recorded messagesOther remote operations Voice Mailbox KX-FP155 only How callers can leave you private messagesTo use a mailbox How incoming messages are recorded in a mailboxRecording your own mailbox greeting messages Menu Stop SETTo check the mailbox greeting message To erase your own mailbox greeting messageTo record a memo message into a mailbox Record Erase SET Stop Play MessagesTo erase all the messages in a mailbox Listening to recorded messages from a remote location To listen to messages in another memory after playbackOption KX-FP155 only Transferring recorded messages to another telephoneRecording your own transfer greeting message To check the transfer greeting messageProgramming Features SummaryGeneral programming method How to set menu options Basic featuresProgramming table VOX ToneAdvanced features Normal Setting the message alert Setting the recording time alert#41 #42Code Feature & Display Settings How the unit operates Setting the friendly receptionSetting the fax voice guidance Setting the auto disconnection#51 #52Check See page 57 for detailsSetting the message transfer Setting the incoming messageSetting the Error Correction Mode ECMSetting the location where you Setting the connecting tone#70 Use this unitFAX only TEL/FAXTAD/FAX YESError Messages ReportsDisplay message Cause & solution DisplayModem Error Polling ErrorTransmit Error Message FullOperations GeneralFax sending Fax receivingUsing an answering machine KX-FP151 only Receiving modeCopying If a power failure occurs Answering device KX-FP155 onlyCannot retrieve recorded messages from a remote location Messages in the mailbox do not play backRecording paper jam JamsPAPER1JAMMED Document jams sending Cleaning Document feederThermal head Do not touch the black sheets on the thermal headPrinted Reports Reference lists and reportsPrint Report Press NAVI.I H Stop MenusetSpecifications Technical data about this productPaper specifications Recording paper size Index Code Feature nameProgram index Index Index PFQX1729ZA KH0502MK0