Panasonic KX-FL511AL Safety Instructions, Other Information, For Best Performance, Fuser unit

Page 8
OTHER INFORMATION:

Safety Instructions

OTHER INFORMATION:

LKeep the unit away from electrical noise

generating devices, such as fluorescent lamps and motors.

LThe unit should be kept free from dust, high temperature and vibration.

LThe unit should not be exposed to direct sunlight.

LDo not place heavy objects on top of this unit. L Do not touch the plug with wet hands.

L Wipe the outer surface of the unit with a soft cloth. Do not use benzine, thinner, or any abrasive powder.

CAUTION:

Laser radiation

LThe printer of this unit utilises a laser. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

2

1

2

Fuser unit

Fuser unit

LThe fuser unit gets hot. Do not touch it.

LDuring or immediately after printing, the area near the recording paper exit (1) also gets warm. This is normal.

Toner cartridge

LBe careful of the following when you handle the toner cartridge:

–Do not leave the toner cartridge out of the protection bag for a long time. It will decrease the toner life.

–If you ingest any toner, drink several glasses of water to dilute your stomach contents, and seek immediate medical treatment.

–If any toner comes into contact with your eyes, flush them thoroughly with water, and seek medical treatment.

–If any toner comes into contact with your skin, wash the area thoroughly with soap and water.

–If you inhale any toner, move to an area with fresh air and consult local medical personnel.

Drum unit

LRead the instructions on page 11 before you begin installation of the drum unit. After you have read them, open the drum unit protection bag. The drum unit contains a photosensitive drum. Exposing it to light may damage the drum. Once you have opened the protection bag:

–Do not expose the drum unit to light for more than 5 minutes.

–Do not touch or scratch the green drum surface.

–Do not place the drum unit near dust or dirt, or in a high humidity area.

–Do not expose the drum unit to direct sunlight.

FOR BEST PERFORMANCE:

LIn the printing process, heat is used to fuse toner onto the page. As a result, it is normal for the machine to produce an odour during and shortly after printing. Be sure to use this

unit in an area with proper ventilation.

LTo extend the life of the drum unit, the unit

should never be turned OFF immediately after printing. Leave the power turned ON for a minimum of 30 minutes after printing.

LStore unused paper in the original packaging,

in a cool and dry place. Not doing so may affect print quality.

LDo not cover slots or openings on the unit. Inspect the air circulation vents regularly and remove any dust build-up with a vacuum cleaner (2).

LWhen replacing the toner cartridge or drum unit, do not allow dust, water, or liquids to come in contact with the drum. This may affect print quality.

6

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Operating Instructions High Speed Laser Fax with Copier FunctionModel No. KX-FL511AL This model is designed to be used in Australia and New ZealandHow to use the operating instructions OPENLocation of controls D E F G HI J K L M N O P Q R S T UThings you should keep a record of Attach your sales receipt hereIMPORTANT NOTICE For Australian usersFor New Zealand users Important information for Australian users Instructions to customerImportant safety instructions Safety InstructionsINSTALLATION SAVE THESE INSTRUCTIONSOTHER INFORMATION FOR BEST PERFORMANCELaser radiation Fuser unit1. Introduction and 1.1 Included accessories 1. Introduction and Installation1.2.1 Available accessories 1.2 Accessory information1.3 Description of buttons 1.4 Overview 1 2 3 4 5 7 8 9 j k l1.5 Toner cartridge and drum unit Toner save feature 1.6 Paper tray 1.7 Paper stacker1.10 Recording paper 1.8 Document stacker1.9 Handset cord Incorrect L The paper should not be over the tabsCorrect 2.1 Connections 2. Preparation2.3 Adjusting volume 2.2 Help function2.3.1 Ringer volume 2.3.2 Handset receiver volume2.4 Date and time 2.5 Your logo RECALL AB SETPress *64#9#1234 2.6 Your fax numberRECALL 3. Telephone 3.1 Storing names and telephone numbers into one-touch dial3.2 Storing names and telephone numbers into the navigator directory 3.5 Making a phone call using one-touch dial and navigator directory 3.3 Editing a stored entry3.4 Erasing a stored entry 3.5.1 Using one-touch dial3.6.1 How Caller ID is displayed 3.6 Caller ID service3.7 Viewing and calling back using caller information 3.8 Printing the Caller ID list 3.9 Erasing caller information3.7.1 Editing a caller’s telephone number before calling back 3.9.1 Erasing all caller information3.10 Storing caller information 3.9.2 Erasing specific caller information4.1 Sending a fax manually 4. Fax4.3 Sending a fax using one touch dial and navigator directory 4.2 Documents you can sendDocument weight 3. Press QUICK SCAN START or FAX START4.4.2 Adding a new entry into the broadcast memory 4.4 Broadcast transmission4.4.1 Programming entries into the broadcast memory 4.4.3 Erasing a stored entry from the broadcast memory 4.4.4 Sending the same document to pre-programmed parties4.5 Selecting the way to use your fax machine 4.5.1 Use only as a fax4.5.2 Mostly phone calls 4.5.3 With answering machine4.6 Receiving a fax manually 4.7 Receiving a fax automatically4.6.1 Activating TEL mode 4.7.1 Activating FAX ONLY mode4.8.1 Setting up the fax machine and an answering machine 4.8 Using the unit with an answering machine4.9 Receive polling retrieving a fax placed on another fax machine LIGHT 4.10.1 Activating the junk fax prohibitor4.10.2 Programming undesired callers 5.1 Using with the ring detection feature 5. Distinctive Ring6. Copy 6.1 Making a copy6.1.1 More copying features L After copying, the collating feature will turn OFF automatically Example Making 2 copies of a 4-page original document7.2 Basic features 7.1 Programming7.1.1 Programming basic features 7.1.2 Programming advanced features7.3 Advanced features Code #06 Changing the ring setting in FAX ONLY modeCode #13 Setting the dialling mode For Australian users only Code #17 Setting the ringer patternCode #31 Activating the Distinctive Ring feature 7.4 Direct commands for programming features #31 Distinctive Ring 8. Help 8.1 Error messages - Reports8.2 Error messages - Display L The inside of the unit is extremely cold and cannot be operated. Use the unit in a warmer area. While the unit cannot be operated, the received documents are temporarily stored into the memory, and will be printed out automatically when the unit warms up 8.3.2 Fax - sending 8.3 When a function does not work, check here8.3.1 General A B C 8.3.3 Fax - receiving8.3.4 Copying 8.3.5 Using an answering machine 8.3.6 If a power failure occurs8.4 Replacing the toner cartridge and the drum unit TONER LOW TONER EMPTYL If you replace the toner cartridge and the drum unit at the same time, skip to step 8.5 Recording paper jam 8.5.1 When the recording paper has jammed in the unitWhen the recording paper has jammed near the drum and toner unit When the recording paper has jammed near the recording paper exit8.6 Document jams - sending 8.5.2 When the recording paper is not fed into the unit properlySee the caution for the drum unit on page 47 for details 8.7 Cleaning the inside of the unitL Be careful when handling the drum and toner unit 8. Help 11 Reconnect the power cord and the telephone line cord 9.1 Reference lists and reports 9. General Information9.2 Technical data about this product Paper specifications Note for recording paperToner life Drum life10.1 Index 10. IndexRecording paper Recording paper size Redialling 26 Page Page Page 1-62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan PFQX1925ZA CM1003MN0
Top Page Image Contents