a/d/s/ iSeries manual Input Type RTD, RTD Submenu, RTD Types, RTD Value Submenu, RTD Values

Input Type (RTD)

ENTER INPUT TYPE MENU:

Press a 1) Press a, if necessary, until CNFG prompt appears. Press d 2) Display advances to INPT Input Menu.

Press d 3) Display flashes T.ç, RTD or PROC (Thermocouple, RTD or Process). If the displayed input type is RTD, press a to skip to step 6 (RTD stops flashing).

RTD SUBMENU:

Press b	4)	Scroll through the available selection to RTD (flashing).
Press d	5)	Display shows STRD stored message momentarily and then
	RTD (not flashing).
Press d	6)	Display flashes previous RTD type selection i.e. 392.2
	(see below for RTD types selection).
Press b	7)	Scroll through the available RTD types to the selection of
	your choice.
Press d	8) Display shows STRD stored message momentarily and then
	advances to RTD RTD value.
RTD Types: 392		385	Two, Three or Four-wire
Display:	392.2, 392.3, 392.4, 385.2, 385.3, 385.4

Last digit indicates: 2-, 3- or 4-wire input.

RTD VALUE SUBMENU:

Press d 9) Display flashes previous RTD value selection i.e. 100_ (see below for RTD value selection).

Press b 10) Scroll through the available RTD values to the selection of your choice.

Press d 11) Display shows STRD stored message momentarily and then advances to RDG Reading Configuration Menu.

RTD Values:	100 ohm	500 ohm	1000 ohm
Display:	100_	500_	1000

20