a/d/s/ iSeries Input Type Process, Reading Configuration Menu, Process Submenu, Process Types

Input Type (Process)

ENTER INPUT TYPE MENU:

Press a 1) Press a, if necessary, until CNFG prompt appears. Press d 2) Display advance to INPT Input Menu.

Press d 3) Display flashes T.ç, RTD or PROC (Thermocouple, RTD or Process). If the displayed input type is PROC, press a to skip to step 6 (PROC stops flashing).

PROCESS SUBMENU:

Press b 4) Scroll through the available selection to PROC (flashing). Press d 5) Display shows STRD stored message momentarily and then

PROC (not flashing).

Press d 6) Display flashes previous Process type selection. i.e. 0-10 (see below for Process types selection).

Press b 7) Scroll through the available Process types to the selection of your choice.

Press d 8) Display shows STRD stored message and then advances to RDG Reading Configuration Menu.

Process Types:	100 mV	1 V	10 V	0 – 20 mA
Display:	0-0.1	0-1.0	0-10	0-20

For 4-20 mA Input select 0-20 mA and adjust the Input/Reading accordingly. To adjust 4-20 mA input, see example under Input/Reading Submenu.

3.2.5 Reading Configuration Menu

It is required that you put the controller in the Standby Mode for any configuration change other than Set Points & Alarms.

Figure 3.4 Flow Chart for Reading Configuration Menu

21