3Com 3C389 manual Error Code Explanation and Action

5-4CHAPTER 5: TROUBLESHOOTING

Table 5-1DOS ODI Error Codes

Error Code Explanation and Action

TOKENCS-DOS-50 PC Card cannot be found or the cable is not attached.

3C389 PC Card has not been inserted in the PCMCIA socket.

Insert your 3C389 PC Card in the socket and try again.

TOKENCS-DOS-204 The shared RAM is on incorrect boundary.

Change the Shared RAM base address and place it on a 16-KB boundary (C0000, C4000, C8000, CC000, D0000, D4000, D8000, DC000).

TOKENCS-DOS-205 The 3C389 PC Card did not reset during initialization.

During initialization, no interrupt occurred.

This can happen if you are using an enabler and it is setting an interrupt level that is different from the interrupt level TOKENCS.COM is using. Check to make sure that both interrupts are the same.

TOKENCS-DOS-206 An interrupt failed to occur during initialization.

During initialization, no interrupt occurred.

This can happen if you are using an enabler and it is setting an interrupt level that is different from the interrupt level TOKENCS.COM is using. Check to make sure that both interrupts are the same.

TOKENCS-DOS-226 The ROM and shared RAM address ranges overlap.

The ROM and RAM memory areas are overlapping.

Check the settings in NET.CFG for MEM #1 and MEM #2. MEM #1 determines the ROM (MMIO) base address. MEM #2 determines the Shared RAM base address. If you are using an enabler, check where it is placing the ROM (MMIO) and the RAM address. ROM is 8 KB in size. RAM is usually 16 KB in size.

TOKENCS-DOS-228 The MAX FRAME SIZE in NET.CFG file is too large (Max=17960).

The maximum frame size has been exceeded.

Change the maximum frame size to a valid value.

TOKENCS-DOS-229 The MAX FRAME SIZE in NET.CFG file is too small (Min=632).

The maximum frame size is too small.

Increase the maximum frame size to a valid value.

(continued)