Panasonic WJ-RT208 manual Setup Procedures, Preparation, Turning the Power On, User Registration

Setup Procedures

1. Preparation

1.1 Turning the Power On

(1)Connect the AC power cord to the AC power connector on the rear panel.

(2)Turn on the power switch on the rear panel.

A hard disk detection screen appears on the monitor for a few seconds.

HDD CHECK 25 %

After that, a live monitoring screen of the camera is dis- played.

1.2 User Registration

(1)When any button other than the camera selection but- ton and the screen split button is pressed while the key- board is locked (in the state of no log-in), a log-in box is displayed.

Input Password
	⋅ ⋅ ⋅ ⋅ ⋅ ⋅ ￿

(2)Enter a password, and then press the [SET] button. When log-in is successful, the indicator of the direction button lights up. (This indicator is not lit up if log-in has not yet been performed or has failed.)

In the case of failure in log-in, the system presents an error dialog box.

Password Error !

Press the [SET] button or the [ESC] button to close the error dialog box.

Note: The default passwords are set as below. Manager: 888888

Operator: 88888

Viewer: 8888

To enhance security, set a new password before using this unit.

We recommend changing these passwords periodical- ly.

The keyboard is automatically locked if any operation is not carried out by the preset time period of "Keylock Time" for "WJ-RT208 SETUP MENU" – "SYSTEM MAN- AGEMENT" – "SYSTEM SETUP".

22