(3)Move the cursor to "PTZ SELECT" and press the [SET] button.
PTZ SELECT
Cam1 
Cam2 
Cam3 
Cam4
Cam5 
Cam6 
Cam7 
Cam8
OK |
| Cancel |
Move the cursor to the desired channel by using the direction buttons (up/down). Select the channel by using the direction buttons (right/left).
In the above figure, "Cam1" is selected in the "PTZ SELECT" menu. No other camera are selected in other channels.
(4)Press the [MENU] button.
(5)Move the cursor to "CAMERA SETUP" and press the [SET] button.
The "CAMERA SETUP" menu appears. Select "PTZ Protocol".
When using the Panasonic’s camera, select "PANA- SONIC" using the direction buttons (left/right).
In other cases, refer to the relevant instruction manual for that camera.
CAMERA SETUP |
| |
Channel No. | 1 |
|
CH Enable | On |
|
Mask Area | Set |
|
Mask Enable | Off |
|
PTZ Protocol | PANASONIC | |
Rec. Reserve | 000 | Days |
Channel Name | CH1 |
|
All | OK | Cancel |
(6)Press the [MENU] button.
(7)Move the cursor to "COMMUNICATION SETUP" and press the [SET] button. Then move the cursor to "RS485 SETUP" and press the [SET] button.
RS485 SETUP
Baud Rate |
| 19200 |
| |
Data Bit | 8 |
| ||
Parity |
| None | ||
Stop Bit | 1 |
| ||
|
|
|
|
|
OK |
|
| Cancel | |
Note: When the Panasonic's camera is used, make set- tings of the respective parameters according to the
Caution: In order to maintain normal communication between this unit and the cameras, it is necessary to have completely correct settings for "PTZ SELECT", "PTZ Protocol", and "RS485 SETUP".
The camera control mode comes in three types. Each time the [SET] button is pressed in the state of monitoring, the mode changes. The related icon is displayed in a lower area of the screen.
•Pan/tilt control mode 
•Zoom/focus mode 
•Iris control mode 
Note: For some types of cameras, some controls many not function. Refer to the relevant operat- ing instructions of the camera and confirm whether this unit is enabled to support controls and connections.
2.5.1 Panning/Tilting
(1)Select the desired channel by using the direction button or numeric button. The image frame of the selected channel blinks.
Select the pan/tilt control mode by pressing the [SET]
button once.
The camera pan/tilt control icon 
is displayed on the screen of the selected channel.
(2)Press the direction button and turn the camera in the proper direction.
Note:
In the pan/tilt control mode, two external units can be connected to the cameras.
When the camera select button [1] is pressed, External Unit 1 is set to ON.
When the camera select button [2] is pressed, External Unit 2 is set to ON.
When the camera select button [6] is pressed, External Unit 1 is set to OFF.
When the camera select button [7] is pressed, External Unit 2 is set to OFF.
(3)Press the [SET] button 3 times to close the pan/tilt con- trol mode.
2.5.2 Auto function (Auto Pan, etc.)
(1)Select the pan/tilt control mode by pressing the [SET]
button once.
The camera pan/tilt control icon 
is displayed on the screen of the selected channel.
(2)Start the auto function by pressing the [PLAY] button.
Note: Refer to the Operating Instructions of the camera for descriptions of the auto function.
29