Record search Search, Camera identification 1

Panasonic WJ-RT208 manual Record search Search, Recording & event setup REC & Event

3.1.2 Record search (SEARCH)

Refer to 3. 2.

3.1.3 Recording & event setup (REC & EVENT)

Timer recording (TIMER REC)

(1)Press the [MENU] button. "WJ-RT208 SETUP MENU" appears.

WJ-RT208 SETUP MENU

SYSTEM MANAGEMENT

REC&EVENT SETUP

PTZ SETUP

CAMERA SETUP

COMMUNICATION SETUP

REPORT

USER INFORMATION

DATA MANAGEMENT

(2)Move the cursor to "REC&EVENT SETUP" and press the [SET] button.

REC & EVENT

TIMER REC

TERMINAL REC

VMD REC

RECORD LENGTH

AUDIO SELECT

(3)Move the cursor to "TIMER REC" and press the [SET] button. The "TIMER REC" menu is displayed.

TIMER REC

Stream type: "CBR" or "VBR"

Default: "CBR" (If screen changes seem extreme, the setting made at "VBR" is preferable.)

Recording date: "SUN", "MON", "TUE", "WED", "THU", "FRI", "SAT", "DAILY"

Two types of "Period1" and/or "Period2" can be set up for one day.

If the same setting is used every day, the setting should be made with "DAILY". When all time spans have been set up, select "On".

Default: 00:00 - 24:00, "Off"

(4)If the same setting is required for all channels, press [All] after completing the setting for one channel. All the parameters are then made identical to that setting.

Current channel information has been copied to all channels!

Press the [SET] button to close the prompt box.

(5)Move the cursor to [OK] and press the [SET] button. Note: When trying to stop the recording by changing

the settings in the process of the timer recording, recording will not stop immediately. The timer recording will not stop until it reaches the end time of the set duration for the timer recording. (When two durations are set, the timer recording will stop when it reaches the end time set later.) To stop the timer recording, stop recording manually after changing the settings for the timer recording.

Terminal recording (TERMINAL REC)

(1)Press the [MENU] button. "WJ-RT208 SETUP MENU" appears. Move the cursor to "REC&EVENT SETUP" and press the [SET] button. (Refer to steps (1) and (2) in 3.1.3.)