Extron electronic MKP 2000 Rear Panel Resets, Control panel security lockout executive mode

Local Operation, cont’d

Control panel security lockout (executive mode)

The front panel security lockout limits the MKP’s front panel operation to input and output selection only (IP address modification is locked).

To toggle the lock on and off, press and hold the 1, 3, Back, and Cancel buttons for approximately 3 seconds until the LED display shows the appropriate “LOC” (on or off) message (figure 3-3). When the MKP lock is turned on, the LED display shows “LOC” for three seconds and then “ON” for three seconds. When the lock is turned off, the LED display shows “LOC” and then “OFF” for 3 seconds.

Simultaneously press
and hold the buttons.					The LED display shows
1		3			the LOC message.
			3			3
				seconds		seconds
BACK	CANCEL				LOC		ON

Figure 3-3 — Control panel lockout

Rear Panel Resets

Performing soft resets

The remote control panel has three soft resets available that restore various tiers of MKP settings to their default settings.

•Events (mode 3) reset — This function restarts the communications and control events.

•IP system (mode 4) reset — IP system reset function resets most IP protocols to their default settings.

IP system reset clears the Internet protocol (IP) settings, but does not reset the target address, the host control setting, the priority setting, or any user-loaded files.

•Absolute (mode 5) reset — Absolute reset performs all of the system reset functions and clears the MKP’s

IP address to 192.168.254.253 and subnet mask to 255.255.0.0. This function is identical to the

Esc ZQQQ SIS command, see chapter 4, SIS Operation).

Perform a soft reset of the MKP as follows:

1.	Press and hold the Reset (R) button until the Reset LED
	blinks off once (events reset), twice (IP system reset), or
	three times (absolute reset) (figure 3-4).

Press and hold			R
			LED flashes
the Reset button.					Release, then
		3	once.
					immediately
Events	R	seconds		R	press and
(Mode 3)					release again.
Reset
Press and hold			R
			LED flashes
the Reset button.					Release, then
		6	twice.
					immediately
IP System	R	seconds		R	press and
(Mode 4)					release again.
Reset
Press and hold			R
			LED flashes
the Reset button.					Release, then
		9	three times.
					immediately
Absolute	R	seconds		R	press and
(mode 5)					release again.

Reset

Figure 3-4 — Soft resets

2. Release the Reset button and then immediately press and release the Reset button again. Nothing happens if the second momentary press does not occur within 1 second.

3-8 MKP 2000 Remote Control Panel • Local Operation MKP 2000 Remote Control Panel • Local Operation 3-9