Extron electronic MKP 2000 user manual Four, SIS Operation, Performing a hard reset

Page 19

Local Operation, cont’d

Performing a hard reset

The hard reset function restores the MKP to the original factory default settings, including the default (factory) firmware configuration and the default IP settings. A hard reset performs all of the reset-whole-MKP functions, absolute reset functions, and erases all user-installed software or firmware. Perform a hard reset as follows:

	Ensure that you have backed up any locally-created
	HTML, JavaScript, or other files that you have uploaded
	to the MKP’s user file space before you perform the hard
	reset. A hard reset will erase all locally-created files
	from the MKP.
1.	If necessary, turn off power to the switcher.
2.	Press and hold the Reset button on the rear panel while
	you apply AC power to the MKP (figure 3-5).
	Press and hold the
	Reset button while you
	apply power to the MKP.
	R
	The LED flashes	Power
	on and off.

R Release the Reset button.

Figure 3-5 — Hard reset

MKP 2000 Remote Control Panel

Chapter4Four

SIS Operation

RS-232 Links

Ethernet Link

Host-to-MKP Instructions

MKP-Initiated (Unsolicited) Messages

MKP Error Responses

Using the Command/Response Table

3-10 MKP 2000 Remote Control Panel • Local Operation

Image 19

Contents MKP Remote Control PanelExtron’s Warranty PrecautionsQuick Start Guide MKP Table of Contents Introduction MKP 2000 Remote Control PanelTable of Contents, cont’d OneMKP 2000 Remote Control Panel Introduction About the MKP 2000 Remote Control PanelRS-232 connection to the switcher Ethernet connection to the switcherTwo InstallationInstallation Procedures InstallationMKP Installation Overview UL Requirements for Wall Box InstallationTo meet the UL listing requirements, this device must be Installation, cont’dPreparing the site, installing the mud ring or wall box Installed in a wall boxDetail a Mounting the MKP to the mud ring or wall boxRear Panel and Side Panel Connections SwitchRS-232 cable termination Control connectionsTP cable termination 11 RJ-45 connector and pinout tablesThree Power supply wiringLocal Operation Front Panel Operations MKP 2000 Remote Control Panel Local OperationLocal Operation Front Panel Controls and Indications Local Operation, cont’d Viewing and configuring the IP and MKP set-up parameters Viewing the last input or output tied from the MKP Input Output Take Host control port setting and pass-through communicationsControl panel security lockout executive mode Rear Panel ResetsPerforming soft resets Four Performing a hard resetSIS Operation Host-to-MKP Instructions SIS OperationRS-232 Links Ethernet LinkUsing the Command/Response Table MKP Error ResponsesSIS Operation, cont’d Xxx.xx Symbol definitions for MKP SIS commandsWhere Command/response table for MKP SIS commands Cont’d SIS OperationMKP Html Operation FiveHtml Operation MKP 2000 Remote Control Panel Html OperationDownload the Startup Html Operation, cont’d System Status System SettingsSwitcher Settings section IP Settings sectionHtml Operation, cont’d Authorized inputs and authorized outputs Port RS-232 SettingsDate/Time Settings fields Front panel configuration lockFirmware Upgrade Html Operation, cont’d PasswordsFile Management Reference Data AAppendix aHtml Operation, cont’d Special Characters Reference Data SpecificationsPart Numbers Drawn to scale may be used as a template Reference Data, cont’d Mounting and Cabling SpecificationsElectrical box cutout Panel mount cutout templateExtron Comm-Link cable Reference Data, cont’d