Extron electronic MKP 2000 user manual Html Operation, cont’d System Status, System Settings

Page 27

HTML Operation, cont’d

System Status Page

The System Status page (figure 5-2) provides an overall view of the status of the MKP, including various IP addresses, the status of the Host and Switch RS-232 ports, and the voltage. The System Status page is the default page that the switcher downloads when you connect to the MKP. Access the System Status page from other MKP HTML web pages by clicking the Status tab.

Figure 5-2 — System Status page

System Settings Page

You can change most of the IP parameters on the System Settings page (figure 5-3). Click the Configuration tab or the System Settings link on the left of the Port Settings, Password, or Firmware Upgrade page to download the System Status page.

Port Settings

Passwords

Firmware

Upgrade

Figure 5-3 — System Settings page

The page is divided into three sections: IP Settings, Switcher Control Settings, and Date/Time Settings. There are three types of controls on the System Settings page: simple fields with no drop boxes, fields with drop boxes, and radio buttons.

Most IP protocol variables, such as the Unit Name, IP Address, Gateway IP address, Subnet Mask, and Switcher IP Address are presented in simple fields.

Most non-IP switcher variables and time and date variables are presented in fields with drop boxes.

On/off and multiple choice selections are radio buttons.

All changes made on the System Settings must be confirmed by clicking the Submit button in the appropriate section. Clicking the Cancel button abandons the changes.

5-4

MKP 2000 Remote Control Panel • HTML Operation

MKP 2000 Remote Control Panel • HTML Operation

5-5

Image 27

Contents MKP Remote Control PanelExtron’s Warranty PrecautionsQuick Start Guide MKP Table of Contents Introduction MKP 2000 Remote Control PanelTable of Contents, cont’d OneMKP 2000 Remote Control Panel Introduction About the MKP 2000 Remote Control PanelRS-232 connection to the switcher Ethernet connection to the switcherTwo InstallationInstallation Procedures InstallationMKP Installation Overview UL Requirements for Wall Box InstallationTo meet the UL listing requirements, this device must be Installation, cont’dPreparing the site, installing the mud ring or wall box Installed in a wall boxDetail a Mounting the MKP to the mud ring or wall boxRear Panel and Side Panel Connections SwitchRS-232 cable termination Control connectionsTP cable termination 11 RJ-45 connector and pinout tablesPower supply wiring ThreeLocal Operation Front Panel Operations MKP 2000 Remote Control Panel Local OperationLocal Operation Front Panel Controls and IndicationsViewing and configuring the IP and MKP set-up parameters Local Operation, cont’dViewing the last input or output tied from the MKP Input Output Take Host control port setting and pass-through communicationsRear Panel Resets Control panel security lockout executive modePerforming soft resets Performing a hard reset FourSIS Operation Host-to-MKP Instructions SIS OperationRS-232 Links Ethernet LinkMKP Error Responses Using the Command/Response TableSIS Operation, cont’d Symbol definitions for MKP SIS commands Xxx.xxWhere Command/response table for MKP SIS commands SIS Operation Cont’dMKP Html Operation FiveMKP 2000 Remote Control Panel Html Operation Html OperationDownload the Startup Html Operation, cont’d System Status System SettingsIP Settings section Switcher Settings sectionHtml Operation, cont’d Authorized inputs and authorized outputs Port RS-232 SettingsDate/Time Settings fields Front panel configuration lockFirmware Upgrade Html Operation, cont’d PasswordsFile Management AAppendix a Reference DataHtml Operation, cont’d Special Characters Specifications Reference DataPart Numbers Drawn to scale may be used as a template Reference Data, cont’d Mounting and Cabling SpecificationsElectrical box cutout Panel mount cutout templateExtron Comm-Link cable Reference Data, cont’d