Ingersoll-Rand ETA2 manual To set up a Characteristic ETA5 only

7529_eng.fm Page 19 Wednesday, November 12, 2003 8:57 AM

To set up a Characteristic - ETA5 ONLY

To set up a job

To start, press	ON
press	MENU
plug in transducer
press	1	(Configure)
press	1	(Edit Char)

Type in Job Name ______________________ , press Enter

Alternatively, when the cursor is flashing, you may connect a Bar Code Reader to the Printer/PC connector on the back of the ETA5 and scan the information from a barcode. Scan across the label (from left or right) and watch the display. If the flashing cursor disappears, the reading has been captured; wait a few seconds for the reading to be displayed. If not, re-scan until the data is accepted.

When the information is displayed on the screen, press Enter
Type in number of samples __________________ , press			Enter
Type in number of subgroups	________________ , press		Enter
Select transducer ID using	, press	Enter
Select units of measure using	, press	Enter
Select ‘Peak’, ‘Impulse’, or ‘Click’ using		; then press		Enter
Select measurement direction using		; then press		Enter
Select cycle end time using		; then press		Enter

19