Ingersoll-Rand ETA2, ETA5 manual Error Messages, Code Message Explanation

7529_eng.fm Page 58 Wednesday, November 12, 2003 8:57 AM

		Error Messages
Code	Message	Explanation
101	RANGE	The selection made is not within the allowable
		range. See the limits specified max to min.
104	EXISTS	The characteristic name entered already exists.
105	NO SPACE	Insufficient memory space is available to create a
		new characteristic.
106	NONE	No characteristics have been created.
107	ON PC	Characteristic or round was sent from PC. These
		may not be edited or erased on ETA.
108	CONV’ OUT	The units selected would generate too great or
	OF RANGE	too small a number.
109	NO NAME	A characteristic name must be entered.
110	NO SETUP	The characteristic exists but configuration is not
		complete.
111	NO DATA	The characteristic exists, but no data is stored.
113	DAT STR	More than one sub group of data is now stored.
114	ALL STR	All of the sub groups for this characteristic have
		now been collected. Erase these after printing to
		allow further collection.
120	NO Tx	Transducer has been selected but none is
		connected.
121	TxID - FLT	Transducer ID level not recognized. Use another
		transducer or get transducer recalibrated.
122	AZ OFSET	An auto-zero calibration on the transducer has
		detected an excessive offset from zero.

58