Ingersoll-Rand ETA2 manual To Store Data single characteristic ETA5 only

7529_eng.fm Page 23 Wednesday, November 12, 2003 8:57 AM

To Store Data (single characteristic) - ETA5 ONLY

At main menu, press

press

3(Store)

1(Single Characteristic)

pressEnter

A job name will appear on screen. If more than one job has been set up in the ETA5, you can scroll through the jobs in sequence using

You can also find your job by typing in the name after you press 1 , then pressing Enter

Alternatively, after pressing 1 , when the cursor is flashing, you may connect a Bar Code

Reader to the Printer/PC connector on the back of the ETA5 and scan the information from a barcode. Scan across the label (from left or right) and watch the display. If the flashing cursor disappears, the reading has been captured; wait a few seconds for the reading to be displayed. If not, re-scan until the data is accepted.

If a further reading needs to be taken, press Reset to clear the data and allow a further scan

to be taken or data to be keyed in.

When correct job appears on screen, press Enter

If you are using an Ingersoll-Rand TRD, TSD or Crane UTA type transducer and it is already plugged in, you are now ready to take readings. The screen will show transducer size and Sub 1 Sam 1

If you are using any other type of transducer or it is not yet plugged in, you will be prompted to insert transducer and select transducer type required.

Plug in correct transducer and press Enter

When you have taken all readings, the screen will show that all torque collection is complete.

To return to the main menu, press MENU MENU

Note: When each reading is taken you will get an audible/visual signal.

23