Sanyo DSR-2108 instruction manual Recording, Continuous recording, Motion recording

Recording

BCONTINUOUS recording

1Recording starts automatically when this unit is turned on.

"C" is displayed on the screen. The connected cameras are simultaneously recorded.

The recording mode can be changed using RECORDING under RECORD settings. Settings, such as image quality, can also be set. (P35)

:A		2%	2009/05/03 09:04:54
CH1	C	C	CH2
	C	C
CH3			CH4

2To stop recording, select "RECORDING" under RECORD settings using the control button ({) and select "DISABLE" using the control button (}~).

“C” disappears.

RECORD
RESOLUTION	FULL
CHANNEL		1
FRAME RATE	1 ips
QUALITY	NORMAL
RECORDING	CONTINUOUS
MOTION ZONE	FULL ZONE
MOTION SENSITIVITY	9
ALARM RECORDING	-- -- -- --
PRE RECORD	OFF
POST EVENT RECORD	5 SECONDS
AUDIO	OFF
TIMER SET
REAL-TIME REC SET

CMOTION recording

A motion sensor can be set for each channel.

1Adjusting the following settings using the control button ({}~).

•	RESOLUTION	•	FRAME RATE
•	CHANNEL	•	QUALITY

2Select "RECORDING" using the control button ({) and select "MOTION" using the control button (}~).

3Select "MOTION ZONE" using the control button ({) and select the "PARTIAL ZONE" using the control button (}~), press the ENTER button.

The motion setting screen is displayed.

• PARTIAL ZONE • FULL ZONE

If "FULL ZONE" is selected, the motion setting screen is not displayed. Only set the level of sensitivity for MOTION SENSITIVITY.

RECORD
RESOLUTION	FULL
CHANNEL		C1
FRAME RATE	1 ips
QUALITY	NORMAL
RECORDING	MOTION
MOTION ZONE	PARTIAL ZONE
MOTION SENSITIVITY	9
ALARM RECORDING	-- -- -- --
PRE RECORD	OFF
POST EVENT RECORD	5 SECONDS
AUDIO	OFF
TIMER SET
REAL-TIME REC SET

Detection

frame

4Select the sensor detection position using the control button ({}~) and press the ENTER button.

The frame set for the sensor detection is grainy. Select a sensor detection position by repeating the operation.

Once the setting of the event searched is complete, press the EXIT/STOP button to return to the RECORD screen.

5Select "MOTION SENSITIVITY" using the control button ({) and select the level of sensitivity using the control button (}~).

Selections: 1-9 (Low sensitivity)

6Select "PRE RECORD" using the control button ({) and select the pre recording as necessary using the control button (}~).

7Select "POST EVENT RECORD" using the control button ({) and select the recording time as necessary using the control button (}~).

Selections: 2 - 30 SECONDS, 1 - 5 MINUTES, 10 MINUTES, 15 MINUTES

8Press the EXIT/STOP button once operations are complete.

Press the EXIT/STOP button repeatedly to return to the live video.

17