Sanyo DSR-2108 instruction manual Setting the Record, BResolution Common to all channels

Remote Setup

E

Setting the Record

To set the recording conditions.

bResolution (Common to all channels)

Sets the resolution for the recordings.

The set value applies to all channels.

• QUAD • FULL • HALF

bChannel-specific settings

These settings apply to the specified channel only.

5 3

1

2

4

6

7

8

9 F G

H

J

K

I

1Channel designation Channel

DSR-2116: 1 -16, DSR-2108: 1 - 8

2Frame Rate

Sets the recording rate.

(OFF, NTSC: 1 - 30 ips/PAL: 1 - 25 ips)

3Quality

Sets the image quality in 5 levels (NETWORK/ECONOMY/ BASIC/NORMAL/FINE).

4Recording

Sets the recording mode.

•DISABLE: Recording disabled.

•CONTINUOUS: Recording is performed while the DVR is on.

•BY MOTION:

Recording is performed when the motion sensor built into this unit detects a movement.

•BY EXT. SENSOR:

Recording is performed when a sensor connected to an external alarm input terminal (ALARM IN) of this unit reacts.

•BY SCHEDULE:

Recording is performed at the time slots specified in the schedule.

5Timer Set

6Motion Sensitivity

Sets the level of detection sensitivity (1 - 9) of the motion sensor.

The lower the value, the higher the detection sensitivity.

7Motion Zone

Sets the zone where the motion sensor is active.

A detection frame needs to be set when "PARTIAL ZONE" is selected. (Refer to P71 for information about the setting procedure)

•FULL ZONE: The motion sensor is active on the whole screen.

•PARTIAL ZONE: The motion sensor is active in a set detection frame.

8Alarm Recording

ALARM recording is performed when an external alarm signal is input to the specified external alarm input terminal

Input terminal DSR-2116:-----, 1 -16DSR-2108:-----, 1 - 8

9Pre Record

Sets whether to perform or not pre-ALARM recording. When enabled, recording is started approximately

5 seconds before the internal motion sensor or the external sensor detector is triggered.

•ON: Pre-ALARM recording enabled

•OFF: Pre-ALARM recording disabled

FPost Event Record

Sets the duration of the ALARM recording

(2 - 30 SECONDS, 1 - 5 MINUTES, 10 MINUTES, 15 MINUTES).

GAudio

Sets whether to perform or not audio recording.

•ON: Recording of audio of live video enabled

•OFF: Recording of audio disabled

HReal Time Frame Rate Sets the recording rate.

(OFF, NTSC: 1 - 30 ips/PAL: 1 - 25 ips)

IQuality

Sets the image quality for real-time recording in 5 levels (NETWORK/ECONOMY/BASIC/NORMAL/FINE).

JPost Event Record

Sets the duration of the real-time recording (--, 2 - 30 SECONDS, 1 - 5 MINUTES, 10 MINUTES, 15 MINUTES)

Memo: If "--" is selected, recording is triggered when the Record/Stop button is pressed or whenever an alarm input occurs.

KAlarm Recording

Sets the alarm input terminal number that triggers real-time recording.

Input terminal DSR-2116:-----, 1 -16DSR-2108:-----, 1 - 8

Sets the schedule for SCHEDULE recording using the [Schedule] screen. (Refer to P71 for information about the setting procedure)

70