[POSITION]menu menu
Select [POSITION] from the main menu in “Navigating through the menu” ( page 37) and choose an item from the submenu.
zzAfter selecting an item, use the ▲▼ to adjust the screen position.
Remote control | Projector controls |
[DOT CLOCK]
This reduces noise that occurs when projecting striped patterns.
When the kind of striped pattern shown below is projected, periodic noise sometimes occurs. In such cases, use the ▲▼ buttons to adjust to the setting with the least noise.
Settings
[H-POSITION]
If the position of the picture projected on the screen deviates when the relative position of the projector and the screen is correctly set, move the picture position horizontally.
Moving left Moving right
If the position of the picture projected on the screen deviates when the relative position of the projector and the screen is correctly set, move the picture position vertically.
Moving Moving upward downward
Note
zzClock adjustment is feasible for COMPUTER (RGB) signal input other than 480i, 576i, 480p, and 576p.
Attention
zz[DOT CLOCK] needs to be adjusted before adjusting the [CLOCK PHASE].
[CLOCK PHASE]
[Available with signals from COMPUTER IN/ COMPONENT IN only]
If flickering of the image or bleeding of contours occurs, make adjustments to ensure the optimum image display.
Use the ◄ ► buttons to adjust noise so that it is not prominent.
Note
zzIf the projecting signal’s dot clock frequency is higher than 154 MHz, adjusting [DOT CLOCK] or [CLOCK PHASE] may not eliminate noise.
zz[CLOCK PHASE] cannot be adjusted when a 480i or 576i COMPONENT (YCBCR) signal is input.
zz[CLOCK PHASE] cannot be adjusted when a 480i or 576i COMPUTER (RGB) signal is input.
zzWhen using digital signal input, adjustment is not feasible.