bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 15
LOF high band
In this line, use the numeric keys to enter the LOF of the high band of your LNB.
Switchover LOF low//high
In this line, use the numeric keys to enter the frequency at which your LNB switches from the low band to the high band. Press OK to accept the setting and store it in memory.
Signal/Quality
If you have entered the parameters of the test transponder correctly, this line will indicate the signal strength and quality.
5.4.4 Rotating antenna
If you are operating the receiver in conjunction with a rotating antenna driven by a DiSEqC motor ( Level 1.2), switch the DiSEqC Control (Point 5.4.1) on and please note Point
8of the operating manmual.
6 Operation
6.1 Switching on and off
>Switch the receiver on by pressing the On/Standby key on the front panel of the unit, or on the remote control.
>Pressing the same key again - on the unit or on the remote control - will switch the receiver off again.
>The unit is now in standby mode, ready for use. Please note:
When switching the receiver off, all current settings are automatically stored in memory. For this reason the unit can only be switched on again after a period of approx. 15 seconds.
6.2 Programme selection
6.2.1 Using the Programme keys up/down
>You can switch from one programme to another, one slot at a time, using the programme keys up/down either on the receiver itself or on the remote control unit.
6.2.2 Using the numeric keys
>You can use the numeric keys to enter the desired
programme number directly. For example:
1 |
|
| for programme slot 1 |
1, | then 4 |
| for programme slot 14 |
2, | then 3, | then 4 | for programme slot 234 |
15