TechniSat DIGITY CI Operating Manual manual Programme Search, Satellite

(Fig. 7-7)

(Fig. 7-8)

(Fig. 7-9)

7.4 Programme Search

As mentioned previously, your receiver is pre-programmed for all programmes available on the ASTRA and EUTELSAT satellites. To receive new programmes, or those of other satellites, several options are available to carry out a programme search/scan.

1. Satellite:

All, to search all satellites selected in the menu LNB Settings (Point 5.4) for programmes

Satellite, to scan only the selected satellite for programmes and bouquets.

2. Transponder:

Select this scan/search function to scan only a specific transponder of a satellite. This will search for individual resp. all programmes of a transponder.

3. Manual Search

Use this type of search to search for for specific programmes for which you have the unique PID numbers available. When the search has been completed, a display will appear on your screen, informing you how many programmes were found and how many of these are new additions.

New programmes will be stored in the Total List. You can then add them to your Favourites List as described under Point 7.1.

>To perform a programme search call up the Main Menu. (Fig. 7-7)

>Use the arrow keys up/down to mark the item Search.

>Confirm by pressing OK.

The sub-menu Search will be displayed. (Fig. 7-8)

>Use the arrow keys up/down to select the type of search you wish to perform.

7.4.1 Satellite

Activating this type of search will scan all active satellites (Point 5.4) and transponders for programmes.

>Use the arrow keys up/down to select the menu line

Satellite.

>Press OK to display the corresponding sub-menu. (Fig. 7-9)

>Press OK again to open the selection table for the active satellites.

>Use the arrow keys up/down to mark the menu line All, to search all active satellites for programmes, or mark a specific satellite to search only this satellite for programmes.