Tandberg Data 7000 manual Installing the monitors, Installing the camera

TANDBERG Videoconferencing System Installation

Installing

Installing the monitor(s)

We recommend that there are 3 people present when installing the monitor(s).

•Remove the plastic plugs located on the back of the monitor(s). Check to see where the holes in the Monitor Rack are located.

•Take the monitor(s) and place it (them) inside the Monitor Rack.

•Secure each monitor with the 8mm hexagonal-shaped screws.

NOTE

REMEMBER THAT THERE SHOULD BE A GAP ON EACH SIDE OF THE MONITOR.

•Remove the protective plastic film from the monitor front.

NOTE

BE CAREFUL WHEN REMOVING THE PLASTIC FILM. DO NOT PULL THE PLASTIC OFF THE MONITOR AT A 90ºANGLE AS THIS MAY DAMAGE THE SCREEN. INSTEAD YOU SHOULD REMOVE THE PLASTIC FILM BY PULLING IT PARALLEL WITH THE SCREEN AT A 180º ANGLE.

Installing the camera

Take the camera and remove the plastic backing from the double-sided pads on the base of the unit. Place the camera centrally on top of the monitor, in line with the front of the screen.

NOTE

THE CAMERA SHOULD BE ALIGNED WITH THE FRONT EDGE OF THE MONITOR TO ENSURE THE IR-SENSOR IN THE CAMERA CAN PICK UP SIGNALS FROM THE REMOTE CONTROL.

15