Maxtor NVR-2028 manual Updating System Software

3.4 Updating System Software

If the system software of the NVR needs to be upgraded, please take the following steps to safely update it.

Important: Before carrying out the following procedures, please ensure the SD card is working and the file of system software is intact

1.Create a directory named NVRVIDEO in the SD Card; if the directory is already existed, move to Step2.

2.Copy the file of MULTI.BIN to the NVRVIDEO-directory.

3.If wireless NVR-2028 is running, please turn off wireless NVR first.

4.Insert the SD card into the built-in SD slot of the unit.

5.Hold down the Up and Down buttons simultaneously, and then turn on the unit.

6.Keep holding down the buttons until the NVR sounds a tone and display the message “ XXXXXX BYTES READ” Now the NVR is updating the system software, which will take approximately 60 seconds to process.

7.Restart the unit when the device sounds a tone twice and displays the messages “PROGRAMMING END” and “ PLEASE RESTART”. The process is complete.

(If you have already followed the procedure 1~5. the unit, however, not being able to power on. Please first check if the SD card you are using is functioning and the file is intact. And then start procedures 1 ~ 5 all over again.)

8.Verify the version of the system software. (Please refer to section 5.7 VERSION option)

PLAY STOP

PAUSE REC

REV FWD

									Seq.
Power	Display	Setup	Search				Enter		Shift	A-rec
	Save		CH1	CH2	CH3	CH4	4	8		T-rec
			CH5	CH6	CH7	CH8

DISK POWER

13 12

Warning: Don’t Interrupt the process while the unit is updating itself and proceed with a SD card containing with no system software of the unit, which would cause the unit hang on.

15