11.2 Change LANCAM SETUP Setting
Please follow the steps given below to change the LANCAM setting through the network as and when necessary.
(1)Click the 
button on the home page to enter the setup mode.
(2)At the top of the page are itemized CAMs 1 to 8, each of which is connected to the corresponding camera. So, if you click any of them, the corresponding camera’s information will appear in the blank spaces of all the items on the screen.
(3)Adjust the LANCAM setup, including all the items on the screen given below:
Enabled LanCam UserName Password
IP Address Quality Resolution Audio Motion
The information in all the above items’ attached spaces can be sent to the NVR.
(4)Click the 
button to submit the new LANCAM setting.
(5)Click the 
button to delete all information given against all the items on the screen.
(6)Click the 
button to return to the home page while the new image setting acts on
the images to effect the desired changes instantly. (If the setting has not been changed by the above steps, any (re)entry onto the home page will find images in their earlier or original setting. )
79