A&D HV-G Series instruction manual Internal Printer for Type V OP-06, Specification, Consumables

Page 63

17.3 Internal Printer for Type V (OP-06)

It is necessary to set the parameter of the “Print mode ( f9 )” in the function table in advance.

It is necessary to set the parameter of the “Date ( f16 )” on the function table in advance.

Caution The date Parameter is not updated automatically.

Specification

Kind

5x7 dot matrix impact type

Characters

16 characters in a line

Width of roll paper 44.5mm

Accessories

a special roll paper, an ink ribbon

Consumables

Special roll paper AX-PP156

Ink ribbon

AX-ERC-05

Operation and Print Samples

Pressing the performed.

F

switch while pressing and holding the

PRINT

switch, paper feed is

Print sample of selecting print mode f9 1

~f9 4

Print sample of selecting print mode f9 5

2.345 kg 2345pc 76.98%

99/12/31

0011.345 kg

0021.325 kg

1.330 kg

Print sample of displaying accumulation data

99/12/31

N 3 Total

7.810 kg

HV-G Instruction Manual Page 62

Image 63
Contents HV-G Series Contents Page Compliance with FCC rules ComplianceOutline and Features Unpacking Type Products Accessories Accessories and Options listOptions List Order code or option name AccessoriesPrecautions for Installing the Scale Precautions for Operating the ScalePrecautions for Storing the Scale Installing the Scale Installing the Batteries for Type L Names OFF Display and SymbolsPage Switches Page Basic Operation Turning the Scale On/Off & Basic WeighingMemo Type L with Batteries Semi-Automatic Tare Input by Weighing Tare and Net DisplayProducts Weighing Range Weighing RangeWeighing Range Operation and PerformanceMode Switch Changing Unit & Mode Storing a Unit Mass Counting ModeCounting the number of articles Storing a 100% Mass Percentage ModeReading Percentage Operation and Switches Accumulation FunctionFunction table Meaning & Purpose Preparation Setting Parameters Example Operation and Performance ExamplesFunction table Meaning and Purpose Comparator FunctionComparator Sign Comparison ConditionAccumulation function f6 Step If one Has Been selected, press Case Full/Dribble Batch Function Comparator Full/Dribble batch sub-functionHold Parameter and display an item of the full/dribble Switch to display the HI Function Table Meaning and purpose Simple batch function Simple Batch FunctionPreparation Setting Parameters Operation and Performance Examples Calibration Adjusting the Scale Gravity Acceleration Table Gravity Acceleration Correction Complete Calibration ProcedureCalibration of the Zero Point Function Table Procedure for Setting Parameters15.2 Parameter List Function or full/dribble batch function Display Meaning and purposePrinting condition when using option OP-06 for type Function to hold the current display value. When 16 RS-232C Serial Data Interface Format Data FormatFormat Preparation and Performance Examples Stream ModeCommand Mode Cancel of tareTare Upper limit value Preset tareFinal value Preparation Setting Parameters Pin connections Pin No Signal name Direction Description Options17.1 RS-232C / Relay output / Buzzer OP-03 17.2 RS-422 / RS-485 / Relay output OP-04 Pin No Signal name Direction DescriptionInstalling OP-04 Communication Format Lower limit value ZeroFinal value Reset of Accumulation data and numberAccumulation data output Accumulation count outputSpecification Internal Printer for Type V OP-06Consumables Installation DisassemblyPerformance Check HV-G series SpecificationsDimensions Page This situation Confirm these items MaintenanceCheck Points Before Calling Maintenance Repair