Graco EQ300C manual Replacing the DataTrak Battery, Replace Battery, Approved Batteries

Page 32

Repair

Replacing the DataTrak Battery

FIRE AND EXPLOSION HAZARD

To reduce the risk of fire and explosion, the battery must be replaced in a non-hazardous location.

Use only an approved replacement battery (see table). Use of an unapproved battery will void Graco’s warranty.

Replace Battery

1.Unscrew cable from the back of the reed switch assembly.

2.Remove the cable from the two cable clips.

3.Remove the DataTrak module from the bracket. Take the module and attached cable to a non-hazardous location.

4.Remove the two screws on the back of the module to access the battery.

5.Disconnect the used battery and replace it with an approved battery.

Approved Batteries

Energizer alkaline #522

Varta alkaline #4922

Ultralife lithium #U9VL

Duracell alkaline #MN1604

32

334667B

Image 32

Contents Important Safety Instructions EcoQuip Vapor Abrasive Blast SystemModels Related ManualsDust and Debris Hazard Burn Hazard Compressor Size and Hose Length Minimum ID Metric OEM System GuidelinesMetric System Component Identification EQ300C and EQ600CDataTrak see DataTrak Controls, DataTrak ControlsKey Pressure Relief Procedure Checklist Before Starting OperationConnecting the Blast Hose and Air Hose Setting Up the Equipment 10 gal 200-500 lb Ti24824a 0 0 0 8 8 0 0 0 3 Blasting Tips Blasting on Higher SurfacesMetering Valve Settings Grit Size Blast Pressure Abrasive Dose Blast Angle GeneralWood SteelUsing the Wash Feature Refilling the Pot with Abrasive Shutting Down Operation Winterizing the Equipment Troubleshooting Problem Cause SolutionSee Cleaning the Auto-Vent Valve, See Repairing the Main Air RegulatorSee Setting Up the Equipment, See Repairing the Diaphragm ValveProcedure see Shutting Down, Intact. See Hose Schematic,Properly. See Hose Schematic, Metering Valve Settings,See Pressure Relief Procedure, Setting Up the Equipment,If flushing does not solve the problem, see Troubleshooting Examples Checking for LeaksPneumatic Blast Control Circuit Repair Repairing the Main Air RegulatorPerform Pressure Relief Procedure, Flushing the Diaphragm Valve Repairing the Diaphragm Valve Perform the Pressure Relief Procedure,Cleaning the Auto-Vent Valve Approved Batteries Replacing the DataTrak BatteryReplace Battery Approved Fuses DataTrak Part Series Letter Fuse Required Replacing the DataTrak FuseReplace Fuse Parts EQ300C and EQ600CEQ300C and EQ600C Parts List Pressure POTEnclosure Enclosure Parts List Part Description QtyRef. Part Description Qty Pressure Pot Parts ListPressure Pot Hose Schematic Vapor Abrasive Blast Systems and Accessories EcoQuip Skid SystemsEcoQuip Trailer Systems Model Series BrakesMobile/Skid Units Trailer UnitsModel Model DescriptionModel Description Type Length Blast Control HosesNozzles Other Accessories Common Spare PartsDimensions EQ600S Technical SpecificationsEQ300S Graco Extended Warranty for EcoQuip Components Graco Information