Polycom 9.0.6 manual Showing, Moving, and Turning Off the PIP, Specifying When to Display the PIP

Getting Started Guide for the VSX Series

Showing, Moving, and Turning Off the PIP

Your system may be configured to display a Picture-in-Picture (PIP) window. During a call on a single-monitor system, the PIP displays what your main camera is sending to the far site. If the far site shows any type of content, the content appears in the main part of the screen, and the PIP changes to show the people at the far site.

During a call on a dual-monitor system, what you see on each monitor and in the PIP depends on how the Polycom system has been configured.

To show, move, or turn off the PIP during a call:

•Press PIP on the remote control to display the PIP on screen.

•	While the PIP has a yellow border, press	PIP repeatedly to move it to
	different corners of the screen.
•	After a brief pause, the PIP border turns blue. Then, press		PIP to turn
	the PIP off.

To swap the views shown in the PIP and the main screen:

1.If the PIP is not showing, press PIP on the remote control to display the PIP on screen.

2.Press Near twice and select the Swap PIP icon.

Specifying When to Display the PIP

Your system may be configured with specific default behavior for the PIP in calls. Depending on your system configuration, you may be able to show, move, or hide the PIP as needed after a call connects.

To specify when to display the PIP:

1.Select System from the Place a Call screen.

2.Select User Settings from the System screen.

3.Select Next to see more settings.

4.Scroll to PIP, press , and select one of these settings:

© Polycom, Inc. 13