Canon P-I9900-QSG-1203 quick start Printer Does Not

Troubleshooting

Problem

Possible Cause

Try This

Printer Does Not		After turning off the computer, other equipment, and then the printer, disconnect
Start or Printer		the FireWire cable connecting other equipment, then try to print again.
	Connected to the
Stops During		It is recommended that you connect only one computer to this printer when using
	computer through
Print Jobs		FireWire for connection.
	FireWire cable with
	other equipment
Cannot Print to	Incorrect page size	Verify that the page size setting matches the size of the paper loaded in the
End of Job	selected	printer:
		- Check the Paper Size setting from within your application to ensure that it
			matches the size of the paper loaded.
		- Check the Page Setup tab in the Printer Properties dialog box of the printer
			driver (for Windows) or the Page Setup dialog box of the printer driver (for
			Macintosh) to ensure that it matches the size of the paper loaded.
	Not enough free	Your operating system may be out of free disk space.
	space on hard disk	Check the available space on your computer’s hard disk.
	The size of the print
	data is too large
		Check the size of the print data. For Windows XP and Windows 2000, if the size of
		the data is too large, part of it may be lost. When the spool format is EMF, follow
		the procedure below.
		1 Open the Printer Properties Dialog Box.
		2 On the Main tab, click Print Option….
		3 Select the Reduce spool data size check box, and Click OK.
			Note	When Reduce spool data size is set, the print quality may be
				degraded.

67