JVC GR-DVL9600 specifications 16 EN, Shooting While Watching The LCD Monitor

16EN

180° 90°

RECORDINGBasicRecording(cont.)

Shooting While Watching The LCD Monitor

Before the following steps, perform step 1 (☞ pg. 14).

PUSH-OPEN Button

Recording Start/Stop Button

Power lamp

		OFF
	Y
	A
P	L	5S

Lock Button

Power Switch

2 ENTER RECORD–STANDBY MODE Make sure the viewfinder is fully tilted downward and pushed back in. Set the Power Switch to the camera position (“ ”, “ ”, “5S” or “ ”) while pressing down the Lock Button located on the switch. Press PUSH-OPENand open the LCD monitor fully.

•The lens cover opens, the power lamp lights and the camcorder enters the Record-Standby mode.

•The scene you are aimed at appears in the LCD monitor, with the word “PAUSE” superimposed upon it.

3 START SHOOTING

Tilt the LCD monitor upward/downward for best viewability (☞ pg. 17) and press the Recording Start/ Stop Button.

•“ ” appears in the LCD monitor while recording is in progress.

4 STOP RECORDING

Press the Recording Start/Stop Button again to stop recording.

•The camcorder re-enters the Record-Standby mode.

NOTES:

●When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this

happens, we recommend that you use the viewfinder (☞ pg. 14).

●To turn the tally lamp off during recording, refer to pgs. 28 and 30.

●For other notes, refer to pg. 15.

Tally lamp

(lights while recording is in progress)