JVC GR-DVL9600 Do not leave the unit, To protect the unit, do not, About moisture condensation

Page 78

78ENCAUTIONS(cont.)

3. DO NOT leave the unit . . .

.... in places of over 50°C (122°F).

.... in places where humidity is extremely low

(below 35%) or extremely high (above 80%).

.... in direct sunlight.

.... in a closed car in summer.

.... near a heater.

4.To protect the unit, DO NOT . . .

.... allow it to become wet.

.... drop the unit or strike it against hard objects.

.... subject it to shock or excessive vibration during transportation.

.... keep the lens directed at extremely bright objects for long periods.

.... expose the lens to direct sunlight.

.... carry it by holding the LCD monitor or the viewfinder.

.... swing it excessively when using the hand strap or the grip.

.... swing the soft camera case excessively when the camcorder is inside it.

5.Dirty heads can cause the following problems:

•No picture during playback.

•Blocks of noise appear during playback. •During recording, the Head Clog Warning

indicator “” appears.

In such cases, use the optional Cleaning Cassette. Insert it and play back. If the cassette is used more than once consecutively, damage to the video heads may result. After the camcorder plays back for about 20 seconds, it stops automatically. Also refer to the Cleaning Cassette’s instructions.

If, after using the Cleaning Cassette, the problems still exist, consult your nearest JVC dealer. Mechanical moving parts used to move the video heads and video tape tend to become dirty and worn out over time. In order to maintain a clear picture at all times, periodic check-ups are recommended after using the unit for about 1,000 hours. For periodic check-ups please consult your nearest JVC dealer.

How To Handle A CD-ROM

•Take care not to soil or scratch the mirror surface (opposite to the printed surface). Do not write anything or put a sticker on either the front or back surface. If the CD-ROM gets dirty, gently wipe it with a soft cloth outward from the centre hole using a circular motion.

•Do not use conventional disc cleaners or cleaning spray.

•Do not bend the CD-ROM or touch its mirror surface.

•Do not store your CD-ROM in a dusty, hot or humid environment. Keep it away from direct sunlight.

About moisture condensation . . .

You have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass‘ outer surface. This same phenomenon occurs on the head drum of a camcorder when it is moved from a cool place to a warm place, after heating a cold room, under extremely humid conditions or in a place directly subjected to the cool air from an air conditioner.

Moisture on the head drum can cause severe damage to the video tape, and can lead to internal damage to the camcorder itself.

Serious malfunctioning

If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from function- ing properly. In such cases, first disconnect its power supply unit (battery pack, AC Power Adapter/Battery Charger, etc.) and wait a few minutes and then re-connect it and proceed as usual from the beginning.

Image 78
Contents GR-DVL9600 Dear Customer It is recommended that youEN3 This unit is produced to comply with Standard IEC PublCleaning Cloth AC Power AdapterRemote Control Unit RM-V711U Video Cable DC Cord Charger AA-V68EA Min DVM-30About DV Luminance Signal Y Lens Colour Difference Signal R-Y/B-YSignal Compression Analysis Mic ConversionPower Charging the Battery PackTilt Viewfinder Upward Attach Battery Pack Using the Battery PackUsing AC Power To Detach The Battery PackDate/Time Settings BatteryGetting Started INSERT/REMOVE Tape Loading/Unloading a CassetteOpen Cassette Cover Close Cassette Cover10 EN Recording Mode SettingSET Recording Mode Set depending on your preferenceGrip Adjustment Viewfinder Adjustment12 EN Shoulder Strap AttachmentTripod Mounting Operation Mode Load a Cassette 14 ENRecording Basic Recording Start ShootingLCD Monitor/Viewfinder Indications Stop RecordingPress IND. ON/OFF Button 16 EN Shooting While Watching The LCD MonitorBefore the following steps, perform pg Journalistic Shooting Interface ShootingBrightness Control Zoom 18 ENBasic Recording Zoom OutProper recording When blank portion is recorded on a tapeAfter playing back the recorded tape, when you shoot again ShootingRecording Advanced Features 20 ENDisplaying The Date And Time During Recording Set the Power Switch to the , , or OFF position Engage 5S ModeEND 5S Mode Dissolves during 5 second recording mode22 EN Progressive Mode RecordingStart Progressive Mode Recording To End Progressive Video RecordingFrame Scan a Scan B Description of Progressive Scan CCDRegular shooting of moving images Scan CRecording Advanced Features24 EN Pro SnapshotPin-Up mode √ Multi-Analyser Motor Drive ModeProgressive Mode To Remove The Shutter SoundSnapshot Flash Auto Flash If the Power Switch is set to26 EN Engage RECORD-STANDBYFlash Brightness Adjustment Access Flash AdjustmentPress the Select Dial Using Menu For Detailed Adjustment 28 ENFactory-preset Recording Menu Explanations30 EN Date/Time Menu ExplanationsSystem Menu Explanations FADE/WIPE Selection Fade/Wipe EffectsEffect Selection Select EffectBefore the following steps, perform steps 1 through 4 on pg 32 ENPicture Wipe or Dissolve Selection If you select Picture Wipe/Dissolve during recordingFader And Wipe Menu MenuManual Mode Item Menu AE/EFFECT Menu Select ModeDisable Mode 34 ENTwilight ShutterClassic Film SepiaAuto Focus Focusing36 EN Patterns that are regularly repeatedManual Focus Access Manual FocusEND Adjustment of Focus To nearer subject38 EN Access Manual Mode Item MenuAccess Exposure Control Exposure ControlIris Iris LockCenter SUBJECT, Lock Iris To Return To Automatic Iris Control40 EN White Balance AdjustmentAccessment White Balance Adjust To Return To Automatic White BalanceManual White Balance Operation Enter SettingExit Manual White Balance Adjustment To Change The Tint For RecordingEngage High Speed Recording Standby 42 ENHigh Speed Recording END RecordingRewind or Fast-forward the tape Adjust VolumePlayback Basic Playback Play BackEN Playback Basic PlaybackProgressive Slow-Motion Playback Find Scene of InterestEND Playback Playback Menu 46 ENPlayback Close MenuPlayback Sound Displaying The Time Code During PlaybackRecording sound Display Output sound Basic Connections When connecting the cables, open this cover48 EN Use the provided S-Video cable and Audio/Video cableConnectinput VCR Output to TV Supply Power Connectvcr Camcorder to TV orTurn on the camcorder, the VCR and the TV Playback Advanced Connections Turn on Power50 EN Connection To a Personal ComputerConnection To a Video Unit Equipped With a DV Connector Connect Printer to PC if Necessary52 EN Tape DubbingStart Playback Digital DubbingMake Connections Press Play 4 to play back the source tapeInsert Battery in Holder Installing The BatteryPull OUT Battery Holder 54ENSwitch set to the camera position Functions ButtonsInfrared beam transmitting window Using the Remote Control Unit 56 ENPlay 4 Button Select Menu Remote sensorEffect SET REMOTE/VCR Code 58 ENRandom Assemble Editing R.A.Edit SET Remote to Operate VCRMake Connections Select ScenesSET EDIT-IN Point EN Using the Remote Control UnitSelect Scenes SET EDIT-OUT PointStop Editing Automatic Editing to VCRPrepare Source Tape RM-V711U Provided T W62 EN For More Accurate EditingDiagnosing VCR’S Against Camcorder Timing Power Switch Playback Menu Adjustment of VCR’S Against Camcorder TimingAccess Playback Menu Input Correction DataBegin Dubbing 64 ENAudio Dubbing Pause During DubbingFind Edit in Point Insert EditingFind Edit OUT Point Pause During Editing66 EN Corrective ActionSymptom Possible Causes Corrective ActionTroubleshooting 68 ENDuring recording, the date EN Troubleshooting After Use Remove72EN Red-Eye Reduction Button # Date/Time Reset Button ResetTally Lamp Power Lamp Control VOLIndications 74 ENIndex LCD Monitor/Viewfinder Indications During RecordingLCD Monitor/Viewfinder Indications During Playback Indications Function76 EN Avoid using the unit To prolong service lifeFor safety, do not To avoid hazardAbout moisture condensation Do not leave the unitTo protect the unit, do not Serious malfunctioningCamcorder AC Power Adapter/Charger AA-V68EAConnectors GeneralGR-DVL9600