JVC GR-DVL9600 specifications Scene 5-second recording, Engage 5S Mode, END 5S Mode

SNAPSHOT Button

Recording Start/Stop Button

Power lamp

F	F	5S
O
Y
A
L
P

Lock Button

Power Switch

Display

MANUAL

REC

PAUSE 444

5S MODE

		After 5 sec.
MANUAL			REC	Record-Standby
	PAUSE
			444
5S MODE

EN21

Scene (5-second recording)

Record a vacation or an important event in 5-second clips to keep the action moving. The 5-Second function may also be activated during Full Auto operation. But the White Balance remains in the previously adjusted condition. While the 5-Second mode is activated, Fade/Wipe effect (☞ pg. 33), Prgram AE with special effects (☞ pg. 35) and other manual operations except the menu settings cannot be performed.

1 SELECT OPERATION MODE

Set the Power Switch to “5S” while pressing down the Lock Button, and pull out the viewfinder fully or open the LCD monitor fully.

•“5S MODE” appears.

2 ENGAGE 5S MODE

Press the Recording Start/Stop Button. The tally lamp lights and beep sounds to indicate the start of recording, and after 5 seconds the camcorder enters Record-Standby mode.

•If you press and hold the Recording Start/Stop Button within 5 seconds after recording starts, Record-Standby mode is not engaged.

3 END 5S MODE

Set the Power Switch to the “ ”, “ ”, “ ” or “OFF” position.

To Take A Snapshot In The 5-Second Recording Mode . . .

.... instead of pressing the Recording Start/Stop Button in

step 2, set the Snapshot Dial to the desired mode, then press SNAPSHOT. The camcorder records a 5-second still (☞ pg. 24). When “SCENE” is set to “ANIM.” (☞ pg. 26) this function is not available.

NOTE:

When “SCENE” is set to “ANIM.” in the System Menu, the 5-second recording mode is not available. Animation recording of a 1/3-second clip is taken instead (☞ pg. 26).

Dissolves during 5 second recording mode

Select “5SD” at the System Menu (☞ pg. 30). “5SD MODE” appears in step 1. Record one 5-second clip, and the image at the end of the clip is stored. If you record the next clip within 5 minutes, the previous scene dissolves as the new scene appears.

•If you turn the power off, the stored image will be lost.

NOTE:

When “DIS” is set to “ON” (☞ pg. 29), dissolve is disabled during 5 second recording mode (5SD). Instead, only simple 5-second recording (5S) of scenes takes place.

Dissolves during 5 second recording mode