JVC GR-DVL9600 50 EN, Playback Advanced Connections, Connection To a Personal Computer

50EN

PUSH-OPEN Button

PLAYBACKAdvancedConnections

Connection To A Personal Computer

To DV

IN/OUT

Core filter

DV cable (optional)

Core filter

To DV connector

PC with DV connector- equipped capture board

To JLIP (DIGITAL STILL) output

Core filter

JLIP-PC connection cable (provided)

To

RS-232C

PC

This camcorder can transfer still images to a personal computer by using the provided software when connected as shown in the illustration. It is also possible to transfer still images to a personal computer with a DV connector- equipped capture board installed.

1 CONFIRM POWER-OFF STATUS Make sure the camcorder and PC are turned off.

2 CONNECT CAMCORDER TO PC

Press PUSH-OPENand open the LCD monitor fully. Connect the camcorder to a PC using the cable according to your PC type as shown in the illustration.

3 TURN ON POWER

Turn the camcorder’s Power Switch to “ ” while pressing down the Lock Button located on the switch and turn on the PC.

NOTES:

●It is recommended to use the AC Power Adapter/

Charger as the power supply instead of the battery pack (☞ pg. 7).

●Never connect the JLIP-PC connection cable and the DV cable simultaneously to the camcorder. Connect only the cable you wish to use to the camcorder.

●The date/time information cannot be captured into PC.

●Also refer to the instruction manuals of the provided Software and the DV connector-equipped capture board.

●Be sure to use a DV cable with the core filter. The core filter reduces interference.

●Be sure to wind the DV cable twice around the core filter attached to the end connected to the camcorder.