JVC GR-DVL9600 specifications After Use, Remove

Turn off the camcorder.

USERMAINTENANCE

After Use

EN71

Remove.

OPEN/EJECT Switch

PUSH HERE

1

2 Slide OPEN/EJECT in the direction of the arrow, then

swing the cover open until it locks. The cassette holder opens automatically. Remove the cassette.

3 Press “PUSH HERE” to close the cassette cover.

4 Press the Battery Release Button and remove the battery pack.

Cleaning The Camcorder

PUSH-OPEN Button	Battery Release
	Button

4

1 CLEAN EXTERIOR Wipe gently with a soft cloth.

•Put cloth in diluted mild soap and wring it well to wipe off heavy dirt. Then wipe again with a dry cloth.

2 CLEAN LCD MONITOR

Press PUSH-OPENand open the LCD monitor. Wipe gently with the provided cleaning cloth or a commer- cially available soft cloth. Be careful not to damage the monitor. Close the LCD monitor.

3 CLEAN LENS

Blow it with a blower brush, then wipe gently with lens cleaning paper.

5	6	7
		Cover
		Blower brush

4 PULL OUT VIEWFINDER FULLY

5 TILT VIEWFINDER VERTICALLY Tilt the viewfinder upward to 90 degrees.

6 OPEN COVER

Open the cover located on the bottom of the viewfinder.

7 CLEAN VIEWFINDER Remove dust using a blower brush.

8 PUSH VIEWFINDER BACK IN Close the cover until it locks in place. Tilt the viewfinder horizontally, and push it back in.

NOTES:

●Avoid using strong cleaning agents such as benzine or alcohol.

●Cleaning should be done only after the battery pack has been removed or other power units have been disconnected.

●Mold may form if the lens is left dirty.

●When using a cleaner or chemically treated cloth refer to the cautions of each product.