JVC Model GR-AX510 manual RE Cordin G Basic Recording, Load a Cassette, Enter RECORD-STANDBY Mode

14

RECORDINGBasic Recording

LENS COVER

SWITCH

POWER

Start/Stop

The power indicator

Tape remaining time indicator

120MIN119MIN3MIN

1MIN (Blinking) 2MIN (Blinking)

0MIN (Blinking)

*MIN.....(Now calculating)

NOTE:

You should already have performed the procedures listed below. If not, do so before continuing.

●Power (☞ pg. 8)

●Tape Length/Recording Mode Setting (☞ pg. 11)

●Grip Adjustment (☞ pg. 12)

LOAD A CASSETTE

1 Slide EJECT to open the cassette holder, then insert the cassette with the label facing out. Press PUSH to ensure the holder is closed and locked.

ENTER RECORD–STANDBY MODE

2 Slide the LENS COVER open/close switch to open the lens cover, then set the power switch to

CAMERA.

•The power indicator lights and the camcorder enters the Record–Standby Mode.

•The scene you’re aimed at appears on the viewfinder screen, with the word “PAUSE” superimposed upon it.

START SHOOTING

3 Press the Recording Start/Stop button.

•The tally lamp lights while recording is in progress, and “REC ” appears in the viewfinder.

STOP RECORDING

4 Press the Recording Start/Stop button again.

•The camcorder re-enters the Record-Standby mode.

NOTES:

	● A cassette holder can’t be opened unless a power
		supply is attached.
	● There may be a delay after you slide EJECT until the
		holder opens. Do not use force.
	● The tape’s remaining time is displayed in the
		viewfinder as shown.
	● ”TAPE END“ appears when the tape reaches its end,
		and the power goes off automatically if left in this
		condition for 5 minutes. ”TAPE END“ also appears
		when a cassette whose tape is already at its end is
		loaded.
	● If the Record–Standby mode continues for 5 minutes,
Tally lamp		the camcorder’s power shuts off automatically. Set the
		power switch to POWER OFF, and then back to
		CAMERA to turn the camcorder on again.
	● If you’re recording on a cassette from the middle, use
		the RETAKE function (☞ pg. 15) to find the end of the
		last recording so you don’t erase any of it.
	● The LENS COVER warning blinks for about 5 seconds
		when the camcorder is turned on, whether the cover is
		open or closed.