Classe Audio SSP-800/CT-SSP owner manual Use Video Next input, Triggers

in use

video

next input

triggers

44

This button identifies active inputs. If theIn Use button is highlighted, then

the Input is active. If the In Use button is NOT highlighted, then the input is considered inactive and is removed from the source selection list.

Deselecting the In Use button for unused inputs is a good way to simplify source selection. The Source menu on the Home page only lists active inputs so, if the In Use button is NOT highlighted in the input setup menu, that input does NOT appear in the Source menu.

The Video button should be used when setting up video sources. It opens the Input Video Connector menu which lists the available video connections on the rear panel, allowing you to identify which rear panel connection the input should use. Any of the rear panel video inputs are assignable to any of the input setups.

The Next Input button scrolls through the inputs from Input 1 to Input 20. So, once you’ve completed the Input 1 setup, click the Next Input button to access the Input 2 setup controls, and so on through Input 20.

NOTE: The Back button returns to the previously viewed menu.

The SSP has two available trigger controls. Each may be programmed to either “logic” (12V) or “inverse logic” (0V) settings. The ability to change the way the trigger operates can solve installation-specific problems that otherwise require external devices that add to both the cost and complexity of your system.

The Event button is used to assign the trigger activation to a specific event. The triggers can be associated with the Standby mode, a specific input, configuration, surround processing mode activation, or even a combination of these. To use the Inverse Logic option, simply highlight the Inverse Logic button on the Triggers setup page.

For more information on the use of DC triggers, we recommend you speak with your authorized Classé dealer.