Vincent Audio SA-96 manuel dutilisation Rear View, Remote Control, Batteries, Power Control

REAR VIEW

REMOTE CONTROL

11. POWER CONTROL

These jack connectors (3.5 mm) send the

signals for the standby control (12V Trigger).

Two devices can be connected directly, for

example two SP-996 mono power amplifiers.

12. OUTPUT REC: Output connectors

assigned to a recording device

If desired, you can connect a recording

device like a CD recorder or a tape re-

11

Point the front of the remote control directly at the front of the appliance, making sure there are no objects between the remote control and the appli- ance.

The distance between the remote control and the appliance should not be more than 7 m, as the reliability of the remote control is affected beyond this range.

Make sure that you do not point the remote control at an angle to the appliance, as beyond an angle of ±30° to the centre axis the appliance may not respond as well to the remote control.

Change both batteries if the distance at which the remote control can be used effectively decreases.

corder to this output. The stereo signal

of this output is identical to the output

signal of the selected audio source at one

BATTERIES

		of the inputs “S1”, “S2”, “S3” or “USB”.
12	13	It is independent of the Volume setting,
		the Mute function and the plugging-in
		of a headphone.
		13. INPUT: Terminal for stereo audio
		signals of the source equipment
		Here you find three stereo RCA input sockets
		for source equipment with analogue stereo
		(line level) audio output.
14		14. OUTPUT: preamplifier outputs

Using batteries

Handling batteries incorrectly can cause battery acid to escape or an explosion in extreme cases.

The batteries must be correctly inserted taking note of the polarity, which is marked in the inside of the battery compartment.

In order to make full use of the batteries’ life, do not mix new and used batteries. Make sure that you insert batteries of the same type.

Changing/Inserting batteries:

a)Open and close the battery compartment cover of the remote control by pushing this cover on the back- side of the remote control in the direction of the arrow marked on it and then removing it.

a

	(2x stereo RCA)
	With these two pairs of connectors you can
15	connect the preamplified stereo audio signal
	of the currently selected source to the power
	amplifier channels. Volume control and Mute
16	affect the signal at the outputs. One or more
	main amplifiers can be connected here to
	supply the loudspeakers.
	15. FUSE: Fuse holder
	This small plastic housing holds the fuse.
	Refer to the security precautions.
	16. AC: Power Connector
	To establish the power supply, connect the
	plugs of the power cable to the device and
	to a wall outlet.

Some batteries are rechargeable, others are not however. Take note of the precautions and instruc- tions that are included on all batteries.

Remove the batteries if the remote control is not going to be used for a long time.

Under no circumstances must batteries be short-cir- cuited, taken apart or heated up.

For environmental reasons, used batteries should be disposed of in accordance with local environ- mental regulations and not put with domestic waste.

Only use AAA (LR3) size batteries.

b)If necessary, remove used batteries and insert new ones correctly as shown by the diagram in the battery compartment.

b

c)Put the compartment cover back on and close the battery compartment.

c

28 Vincent Vincent 29