NordicTrack CTK65020 Symptom the Power does not Turn on, Symptom the Power Turns OFF During USE

T ROUBLE -SHOOTING

Most INCLINE TRAINER problems can be solved by following the steps outlined in this section. Find any symptoms that apply, and follow the steps listed. If further assistance is needed, please call Customer

Care toll-free at 1-800-201-2109, Monday through Friday, 8 a.m. until 5 p.m. Mountain Time (excluding hol- idays).

1.SYMPTOM: THE POWER DOES NOT TURN ON

a.Make sure that the power cord is plugged into a properly grounded outlet. (Refer to page 10.)

b.Make sure that the key is inserted into the console.

c.Check the on/off circuit breaker located on the INCLINE TRAINER near the

power cord. Make sure that the on/off circuit breaker is switched to the on position.

2.SYMPTOM: THE POWER TURNS OFF DURING USE

a.Check the on/off circuit breaker located on the INCLINE TRAINER near the power cord. (See drawing 1. c. above.) Make sure that the on/off circuit breaker is switched to the on position.

b.Make sure that the power cord is plugged in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the power still turns off during use, please call Customer Care toll-free.

3.SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON

c

“On” Position

a. If the walking belt is overtightened, performance may

decrease and the walking belt may be damaged. If

the walking belt is properly tightened, you should be able to lift each side of the walking belt 1 to 2 inches

off the walking platform. If adjustments need to be made, first remove the key and unplug the power

cord . Using the included allen wrench, turn both roller adjustment bolts counterclockwise 1/4 of a turn. Be careful to keep the walking belt centered. Plug in the power cord, insert the key, and use the INCLINE TRAINER for a few minutes. Repeat until the walking

belt is properly tightened.

a

1”–2”

Roller Adjustment Bolts

b. If the walking belt still slows when walked on, please call Customer Care toll-free.

33