Diamondback 1190 Sr manual I N T E R a C T I V E P R O G R a M S

Page 30

1190SROM 9/22/06 1:51 PM Page 32

PROGRAM

PROFILE

Workout Programs, continued

•If no pulse is detected, the Pulse display will show “- - -” until there is a pulse, and the HR bar graph will not be illuminated.

•If a pulse is detected, the Pulse display will display the BPM, and the HR bar graph will illuminate to indicate your %Max. HR.

Adjusting Intensity Level

•Press “UP/DOWN” key to adjust the intensity level to L1 and up to L20 during anytime of the program.

•Each time, the “UP/DOWN” key is pressed; it will adjust the intensity level of the remaining of the program.

Pause, Reset, Switch, Stop or Save the program

See Basic Operation section for details.

Ending the Program

•When the selected program time is up or the “STOP” key is pressed, there will be a beep to signify the end of the program and Cool Down will become active

•The message window will scroll the messages “THE PROGRAM ENDED” then “3:00 COOL DOWN BEGIN”

•The “Start” key can be pressed to re-start the program.

•The “Stop” key can be pressed to skip the cool down mode and activate the Workout Summary immediately.

H R I N T E R A C T I V E P R O G R A M S

All HR Interactive programs use heart rate feedback to control the resistance settings of the unit. In HR Interactive Programs, the resistance level cannot be changed manually, since your heart rate is used to determine the ideal resistance settings during the pro- gram execution.

A HEART RATE MONITORING DEVICE (HAND GRIPS, CHEST STRAP) MUST BE USED FOR ALL HR INTERACTIVE PROGRAMS TO FUNCTION PROPERLY. FOR BEST RESULTS, USING A CHEST STRAP IS RECOMMENDED.

IMPORTANT: It is dangerous to exceed 95% of your maximum heart rate while you are exercising. Please consult your physician before performing any Heart Rate based train- ing program.

TARGET HEART RATE PROGRAM

Getting Started

The Target Heart Rate program is designed to keep you training at your chosen heart rate level. The 1190 will adjust the intensity level automatically to ensure your target heart rate is achieved and maintained during the entire program. The profile on the Dot Matrix display will show % Max HR for this program rather than intensity level. The profile is replaced with LEDs indicating your actual achieved HR as the program exe- cutes. The LEDs will blink to show your current position in the HR profile.

Beginning the Program

Start pedaling the unit. The message window will scroll a message “SELECT A PRO- GRAM”.

30

1190 Sr Owner’s Manual

 

 

Page 29 Page 31
Image 30
Page 29 Page 31
Contents 1190SROM 9/22/06 151 PM To Activate Warranty Purchaser’s Reference InformationShipping Materials Table of Contents Introduction Safety Instructions and Warnings Figure aAssembly Drawing Rear Stabilizer Bar Assembly InstructionsTools Required Console Mast & HandlebarRear Handlebar Seat & Seat BackPedal Assembly Seat Back CoverGood health is an exercise in common sense BMI = weight lb ÷ height2 in xExercise guidelines Heart rate is an important key to your exerciseMaximum Heart Rate & Training Zone Quantity & Quality Get a smart start on exercisingPulse Hand Grips Standard How to Wear Your Sensor/ TransmitterHeart Rate Monitoring Devices Chest Strap StandardHeart Rate Monitoring Devices Default values ConsoleGlossary of Terms Console Layout and Controls Function Keys Basic Operation Basic Operation Workout Programs R M U PO L D O W N Ending the Cool Down R K O U T S U M M a R YI C K S T a R T A S S I C P R O G R a M S Random Program Workout Programs Program Profile Interval ProgramHill Climb Program Workout Programs Strength Program I N T E R a C T I V E P R O G R a M S Workout Programs Heart Rate Interval Program Workout Programs Fatburner Program Workout Programs Cardio Program Workout Programs Workout Programs Maintenance Domestic warranty Information What is CoveredWarranty voided if Diamondback Fitness, Inc Warranty card Diamondback Fitness Warranty CardCamarillo Ranch Road Camarillo, CA
Top Page Image Contents