27. Identify the Low Cable (72). Route the Cable | 27 |
| |
through the Backrest Upright (8) and under a |
| ||
|
| ||
110mm Pulley (59). Attach the Pulley inside the | 8 | 79 | |
Upright with an M10 x 93mm Button Bolt (97), | 84 | ||
two M10 Washers (84), two 25mm Spacers (55), | 72 | 55 | |
| |||
and an M10 Nylon Locknut (79). |
| 59 | |
| 84 55 | ||
|
| ||
| 97 |
| |
28. Route the Low Cable (72) over a 90mm Pulley | 28 |
| |
(58). Attach the Pulley and two Half Finger | 79 | ||
| |||
Guards (40) to the Double |
| ||
100 |
| ||
an M10 x 46mm Button Bolt (100) and an M10 |
| ||
Nylon Locknut (79). |
| 40 | |
| 40 | 46 | |
| 58 | ||
|
| ||
|
| 72 |
29. Route the Low Cable (72) under a 90mm Pulley | 29 |
|
|
(58). Attach the Pulley and two Half Finger |
|
| |
|
| 72 | |
Guards (40) to the Center Base (2) with an M10 x |
|
| |
|
| 100 | |
46mm Button Bolt (100) and an M10 Nylon |
|
| |
|
|
| |
Locknut (79). |
|
|
|
|
| 58 | 40 |
| 40 |
|
|
| 79 | 2 |
|
30. Wrap the Low Cable (72) over a 90mm Pulley | 30 |
|
|
(58). Attach the Pulley, a Small Cable Trap (63), |
|
| |
|
|
| |
and two Half Finger Guards (40) to the second |
|
|
|
hole from the bottom of the two Pulley Plates (74) |
|
| 79 |
with an M10 x 53mm Button Bolt (147) and an |
|
|
|
M10 Nylon Locknut (79). Make sure that the |
| 74 | 40 |
Cable Trap is oriented to hold the Cable in the |
| ||
|
| 74 | |
groove of the Pulley. |
|
| |
|
|
| |
|
| 40 | 63 |
|
| 147 | 58 |
|
|
| |
|
|
| 72 |
16