43.Route the Long Cable (54) over a 90mm Pulley
(58).Attach the Pulley and a Small Cable Trap
(63)to the right Side Top Frame (13) with an M10 x 49mm Button Bolt (104) and an M10 Nylon Locknut (79). Make sure that the Small Cable
Trap is oriented to hold the Cable in the groove of the Pulley.
44.Route the Long Cable (54) through the Right Upright (4) and a Swivel Arm (32). Then, route the Cable over a 90mm Pulley (58). Attach the Pulley inside the Swivel Arm with an M10 x 53mm Button Bolt (147), two M10 Washers (84), two 6mm Spacers (75), and an M10 Nylon Locknut (79).
45.Slide a Clip Cover (52) onto the Long Cable (54).
Hold an M6 Nylon Locknut (80) inside of a Clip (53), and insert the Long Cable (54) into the Clip and the Nylon Locknut. Hold the crimp on the Cable with a pair of pliers. Insert a screwdriver between the Nylon Locknut and the Clip. Rotate the screwdriver, the Clip, and the Nylon Locknut together until two threads of the Cable show past the Nylon Locknut.
Slide the Clip Cover (52) over the Clip (53).
46.Attach the Butterfly Backrest (29) to the Backrest Upright (8) with two M6 x 64mm Screws (89) and two M6 Washers (86).
43 |
|
54 | |
79 | 63 |
| |
13 |
|
104 | 58 |
| |
44 |
|
54 |
|
32 | 84 |
75 | |
58 | 79 |
| |
147 | 4 |
| |
75 |
|
84 |
|
45 |
|
54 |
|
52 |
|
53 | 80 |
46 |
|
8 | 89 |
| |
| 86 |
29 | 89 |
| 86 |
20