Place the right side upright support near the base frame side bracket. Feed the display cable through the upright support.
Note: If you encounter difficulties feeding the cable, tie a string to the cable connector and the other end to a washer. Feed the washer through the upright support and pull it and the cable connector out of the base hole. Remove the string.
Pull the cable through the side bracket hole in the base frame, and then connect the cable to its receptacle on the lower board near the motor.
Secure the upright support to the side bracket using two socket head screws (C), two washers (E), and two barrel spacers (F). Secure the upright support to the front panel using two screws removed in step 2 and two washers (B) from the hardware kit. Finger tighten.
Important: Do not securely tighten the screws until the unit has been fully assembled. Make sure the fasteners do not pinch the cable. Cables damaged by improper installation will not be covered by the Precor Limited Warranty.
Note: Place excess cable inside the upright support.
Secure the display console to the right upright support using two buttonhead screws (A) and two washers (B). Finger tighten.
Commercial Treadmill Assembly Guide | 5 |